Quote:
Originally Posted by hifisharu
My guesses to the problem of the idling screw falling out is that have you guys dialed in a very low idling value, say 900 +/- 100 and the screw is held only by a couple of threads, which due to vibration can fall out? Correct me if I'm wrong,  |
Nop. If I am not wrong if you make it to right/clockwise, it will be tight. Means idle RPM will get lesser, towards 900 RPM. If you turn anticlockwise then its will increase towards 1300 RPM. It was at normal. 1200-1300 RPM.
Quote:
Originally Posted by jd666
^^ true. alternate is to fix it and apply tape over it to secure in place.
|
Ya. This seems to be the correct measure for this issue as of now
.
Thanks for replying... hifisharu & jd666