This is my First post in this forum.
Before I Ask my Question here is a disclaimer -
I am not a professional CAD or Mechanical Engineer to know much about this.
My Question below might be stupid to some of the experts but please do reply after a good Laugh .
Also, All information I have is from the internet and have NO practical knowledge.
Here we go then.
I am currently working on building a High Performance Free Flow Exhaust for my Bike (Yamaha FZ16).
Attached is the CAD design I made for the Exhaust (I am not a professional CAD designer but recently started it as a Hobby - by the way this is my first CAD Drawing).
I was looking in to Details about how to make a FFE.
I got a formula to develop a FFE.
Here is the link to Document which gives details on how to calculate the Diameter/Length of the pipe.
Using the above formula I get the Diameter, Length of the header pipe, secondary cone etc.
When I calculate the formula I got Diameter of the Primary Pipe around 30mm.
I took 35mm as I will have bend just after the Gases Come out of the Exhaust Port. (Bend After 60mm from the Exhaust Port - Please refer Images Attached)
Figure : All Dimensions
Primary Pipe - Measurements (Please refer Images for this)
From my mock up CAD design I have taken the Main Pipe (From Exhaust Port till secondary pipe) Diameter as 35mm and length of which is around 650mm (65cms).
Secondary Pipe Diameter I have taken as 45mm at the Expanded area (cone moves from 35mm dia to 45mm dia in about 100mm length).
For the next 200-250mm I have the same Diameter of 45mm till the muffler. I have designed a slip-on muffler which gets connected to the this pipe (you can see in the CAD drawing).
Figure : Without Muffler
Figure : 3D View.
Muffler Design - Measurements ( Measurements are taken looking at the Stock Muffler on the bike - Have increased about 10% as of the stock Muffler)
For the Muffler I have taken 350mm length, 100mm diameter and
Exhaust output diameter without DB Killer will be 60mm (double the Exhaust Port). (ON Stock Muffler this is 20mm)
With DB Killer Exhaust output diameter will be 30mm (same as Exhaust Port). (Design - UNDER PROCESS)
Figure : Muffler - Without DB Killer
ALL THE ABOVE DIAMETER INFORMATION IS INTERNAL DIAMETER.
Question: Can someone please verify if the measurement are correct or it needs few more tweaking to get desired High Performance.
Question : Also, If someone can tell me where I can get this Exhaust Done in Bangalore.
Engine: 153cc, 4-stroke
Maximum Power: 14 Bhp @ 7500 rpm
Maximum Torque: 14 Nm @ 6000 rpm
Gears: 5 Manual
Clutch: Constant Wet Multi Plate
No. of Cylinders: 1
Valve Per Cylinder: 2
Chassis Type: Diamond
Cooling Type: Air Cooling
Awaiting your Responses.