xBhp.com : The Global Indian Biking Community

Register Now for FREE!
Are you registered on xBhp yet? If not, do so now and start participating to be able to share photos and experiences with other members. It will also enable to you have a chance to be a part of xBhp contests and roadtrips in the future! Username: Password: Confirm Password: E-Mail: Confirm E-Mail: Birthday: Image Verification I agree to forum rules

Showing Visitor Messages 1 to 5 of 5

03-28-2012 01:08 AM - permalink
ashwinprakas

Ride the bike for say about 10~20Kms and ride hard. Let the engine completely warm up, then set the idle to 1500Rpms. And does the bike die while engine braking??? i.e your ridig at 60, then you decide to slow down and downshift, as soon as you leave the clutch bike dies... Anything like that????
- Reply or View Conversation
03-28-2012 12:57 AM - permalink
ashwinprakas

I've given a list of things to try in the ZMA thread. Take a look.
- Reply or View Conversation
03-28-2012 12:56 AM - permalink
ashwinprakas

Whats your idle speed??? And did the SVC tune your carb???? Was your bike out during rains???
- Reply or View Conversation
03-28-2012 12:46 AM - permalink
ashwinprakas

There a plastic cap on the crank case next to the kicker. In my bike its kinda ash in colour.

Did you experience any compression loss after the bike stalled??? i.e did the kicker move down with resistance or did it move down loosely.
- Reply or View Conversation
03-28-2012 12:19 AM - permalink
ashwinprakas

At what RPM were you riding when the bike stalled???
Remove dipstick and wipe it clean, now put it back(dont screw) pull back and check. It should be close to the top ring.
- Reply or View Conversation