Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Castrol Power 1

Fatigue, sleepiness, & alcohol are the same.

Our Partners

Announcement

Collapse
No announcement yet.

[Help]: Pulsar 135cc - starting problem after 1st service

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Ayson
    replied
    The initial RPM increase is most likely the autochoke. Please read through this thread.

    http://www.xbhp.com/talkies/help-me/...ting-down.html

    There was your same problem and it has been solved. If those solutions don't work we can investigate further.

    Leave a comment:


  • jd666
    replied
    its a case of cold rpm being too low and warm rpm being too high..

    run your bike for a few kms, kep the revs on the higher side, basically let the engine get hot, come to temperature, then see the status of the idle rpm. If its around 1000-1200, then you need to get the idle rpm increased. If it jumps to above 1500 rpm, then you need to get the carburettor adjusted.

    Leave a comment:


  • AAPulsar
    replied
    Check your RPMs after the bike is warm... it should be around 1300-1400 I guess.

    Leave a comment:


  • Aryan
    replied
    Query Moved and Approved.

    Leave a comment:


  • [Help]: Pulsar 135cc - starting problem after 1st service

    Hi All,

    I bought pulsar 135cc last month and it has been running good.
    However theres some problem with it while starting.
    When i start the bike in morning or after 5-6 hrs,from the starting only the initial rpm would move to 3-3.5 . But in 5-8 secs would come down to normal and i could move on in 1st gear. I thought may be its taking oil when its start for the first time, because if i drove the bike for a while and started again soon, its rpm would be around 1.
    After servicing that problem is no more, but now if i start for first 1-2 minute of driving if the speed is around 11-12 km/h, the engine would automatically stop.
    I have lot of steep speedbreakers in my office's garage,so i have to apply breaks from the start only.The bike doesn't stop if i keep on giving race.
    I think petrol doesn't reach my engine initially.But being a novice i don't know what to tell to the mechanic.Please help
Working...
X