Hi Guys,
Id like to share my projector setup that i did for my pulsar 200ns,

Things Required
1) Led projectors (available for around 1500 rs is ebay) and led ones are better than HID ones, i can see jts around the same brightness and much easier wiring
2) heat gun
3) spanners to remove the headlight

So lets get started,
First thing you open up all the screws and bolts that are hildung the headlight in place, this took around half an hour for me,
Once you have the headlight out you take it back home and then heat the edges with a heat gun,.. Make sure not to heat just one area but move it around and pry it open,
Once ur headlight is open its preety simple,
The you unscrew the projector and the cooling fan
Put the projector from the front side, pull the wires out of the hole for the headlight and then screw the back part of projector from the behind
Then you snap the headlamp back, seal it with silicone and leave it to dry over night
As said, led projects are much simple it just has 3 wires for ground, hi beam and low beam whichbyou connect directly to the previous headlight wire and then connect the angel eyes wire to your parking light wire,
Put it all back n you are done
New to the forum let me try posting some pictures