Tweet
HELP: 180 UG3 Engine problem
hi all...i have a Pulsar 180 the ug-3 model which is 2 years old and off late i am experiencing a strange problem the engine goes off after a few kms of riding say at a speed of 60kmph...and i have to wait for a few mins before i can start it again...why's this happening?
-
-
Query ApprovedJoin xBhp On
-
i'm not an expert but... make sure that all the fuel pipes are flowing ok. have the carburettor checked and cleaned.
check the plugs. check the spark.
check the airfilter.
can't think of anything else now... maybe someone will chip in.Comment
-
It Could be of Fuel Blog
Check this
Plan for a 20KM no-stop ride
Before the ride starts- Open your Feul tank lid for some seconds - shake your bike by sitting (make sure no fuel comes our of the lid)
close the lid and drive it continuously
If it rides non-stop ---- then its a Fuel Blog problem
GO to a Mec who can service the Fuel Tap and some Air logging partsComment
-
Thanks for all the replies guys...will try what each of you mentioned and get backComment
-
tried what u said...rode the bike for more than twenty minutes non stop and the engine didn't go off or anything...now i need to fid a good mechOriginally posted by Thunder View PostComment
-
just got a k&N on my bike, am just not able to go above 119!!!!! earlier i easily did a 125 in a straight line....Comment
-
K&N is for some Initial Torque and some Mid-range Power - thats it ------- It will not give you an increase in your maximum SpeedOriginally posted by me is rossi View Post
My option will be staying with the Stock Air Filter ---- rather than K&NComment
Comment