Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Castrol Power 1

Careful with that leaking water tanker ahead.

Our Partner

Announcement

Collapse
No announcement yet.

pulsar150 starting issue

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • pulsar150 starting issue

    Hello bikers,
    I own a pulsar150 UG 4.5(9,000KMS done)
    the problem that i'm facing is that when i turn off the fuel tap and leave the bike for 2-3 days the bike refuses to start<<
    however when i leave the fuel supply on and then leave the bike for same no. of days the bike starts in one go
    this problem exists all time of the year whether hot or cold
    i've checked the fuel lines and air filter fir choking and replaced both the spark plugs.
    is there a possibility that the carburettor's float bowl is having a leak somewhere ??
    Pulsar Engine Oil Filter Cleaning

    D.I.Y. Surface Discharge Spark Plug

    My Pulsar's exhaust sound

  • #2
    Query approved.
    (Been There Done That) x 3.25

    Comment


    • #3
      Originally posted by V!RU$ View Post
      Hello bikers,
      I own a pulsar150 UG 4.5(9,000KMS done)
      the problem that i'm facing is that when i turn off the fuel tap and leave the bike for 2-3 days the bike refuses to start<<
      however when i leave the fuel supply on and then leave the bike for same no. of days the bike starts in one go
      this problem exists all time of the year whether hot or cold
      i've checked the fuel lines and air filter fir choking and replaced both the spark plugs.
      is there a possibility that the carburettor's float bowl is having a leak somewhere ??
      that's not a real problem and happens with my dazzler too. the only solution(as far as i know) is on the fuel for 5 min then start the bike. It should start, if it doesnt start use the choke for a min(but dont start the engine). Then close the choke and start the engine.....

      Comment


      • #4
        also i would like to add that my right spark plug fouls at 3000-4000 kms and that's quite less i guess ??
        i've changed 2 spark plugs in 10,000 K.M.S. !!!
        both on the right side
        the ignition coil is ok
        and i used the correct heat range for spark plugs
        could it be due to a little lean mixture that i'm currently using??
        also my engine sounds tik-tik at idle rpm not that much but it is audible if you pay attention
        Pulsar Engine Oil Filter Cleaning

        D.I.Y. Surface Discharge Spark Plug

        My Pulsar's exhaust sound

        Comment


        • #5
          Clean the carb float bowl ,drain-tube, float and float hinge pin . Replace the float-valve .. the pin like thingy with a black rubber tip . While you are at it , you may as well clean the jets & other carb parts too in one go .

          Comment


          • #6
            Thanx everyone for their advice
            the heat range of both the spark plugs is same in the manual
            can we try different heat range spark plugs on either sides ??
            any recommendations ??
            also i'm planning to go for dual electrode spark plugs any suggestions
            P.S. i don't have enough budget for the expensive NGK's or worthless ignition cables !!!
            Last edited by V!RU$; 12-06-2011, 03:33 PM.
            Pulsar Engine Oil Filter Cleaning

            D.I.Y. Surface Discharge Spark Plug

            My Pulsar's exhaust sound

            Comment


            • #7
              Originally posted by V!RU$ View Post
              also i would like to add that my right spark plug fouls at 3000-4000 kms and that's quite less i guess ??
              i've changed 2 spark plugs in 10,000 K.M.S. !!!
              both on the right side
              the ignition coil is ok
              and i used the correct heat range for spark plugs
              could it be due to a little lean mixture that i'm currently using??
              also my engine sounds tik-tik at idle rpm not that much but it is audible if you pay attention
              tik tik sound is also audible in my bike... IMO maybe all bajaj bikes have this character.
              Its the fusion of a two wheeled machine & a human being which creates a true biker.

              Fine me on facebook: https://www.facebook.com/krazzykid.abhijeet

              Pulsar spare parts price list (indicative only):
              http://www.scribd.com/doc/42303845/P...re-Parts-Price
              http://www.scribd.com/doc/99085008/Bajaj-180-Pulsar-UG3

              Comment


              • #8
                i'm also trying for dual electrode spark plugs.....please give more theoretical info on this...
                I'm a responsible rider.It doesn't matter what you ride,but what matters is how you ride.

                Comment


                • #9
                  thanx everyone
                  also i would be very grateful if anyone can throw some light on alignment of rear wheels??
                  i'm looking forward to some DIY schemes..
                  Pulsar Engine Oil Filter Cleaning

                  D.I.Y. Surface Discharge Spark Plug

                  My Pulsar's exhaust sound

                  Comment

                  Working...
                  X