Tweet
Help : Cylinder boring at TVM ?
Where can I bore an engine at or near TVM (properly done, without narrowing obviously)
or anywhere that is as near as it gets
or anywhere that is as near as it gets
-
sigpic -
Query Approved.:) -
What bike? Pls provide as much details as possible & the current piston sizes.Skill is what keeps you on a Motorcycle
Awareness + Skill is what keeps you out of harm's way
ATGATT + Awareness + Skill means you might Live To Ride another dayComment
-
sorry for that,
its a classic CBZ engine, 156.80 cc
current stock setup is 63.5mm bore,49.5mm stroke
i want it bored to run a piston size of 67mm
also if possible how much it might cost me to do this
also port polishing needed but boring first
(but its not just bikes i want to kno where it can be done for cars as well)Last edited by N-bo; 02-14-2010, 07:06 PM.sigpicComment
-
Cars????
But why???
Anyway for CBZ, your best bet would be is to get it done at HH showroom. Reason? They'll have accountability & genuine parts, transparent billing (atleast better than any local garage).
If you've any bad experience with any HH A.S.S, then walk into all other H.H.A.S.S. Always make multiple enquires about the work the A.S.S is going to carry out with all the A.S.S (don't trust any one A.S.S). Finally hand over the work to the one A.S.S who sounded better. Good Luck.Skill is what keeps you on a Motorcycle
Awareness + Skill is what keeps you out of harm's way
ATGATT + Awareness + Skill means you might Live To Ride another dayComment
-
Didn't know authorized service centers carry out such mods. @threadstarter: Get it done from a local machining expert. make sure he is a good one.Originally posted by aargee View PostCars???? But why???
Anyway for CBZ, your best bet would be is to get it done at HH showroom. Reason? They'll have accountability & genuine parts, transparent billing (atleast better than any local garage).
If you've any bad experience with any HH A.S.S, then walk into all other H.H.A.S.S. Always make multiple enquires about the work the A.S.S is going to carry out with all the A.S.S (don't trust any one A.S.S). Finally hand over the work to the one A.S.S who sounded better. Good Luck.Comment
-
i dint know that service centers do this as well,will check that out..
anyway the point of starting this thread was if any of you personally know some local machining place where i can get this done then it would be much easier for me (contact no.,, address,, anything like dat,,,)
any mallu reading this pls give a reply..sigpicComment
-
try posting this query in the TVM G2G thread.Smoke rubber,not tobacco.
-Life Through-the-Lens
-For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!Comment
Comment