Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Axor
Magazine
Castrol Power 1

Clean visor equals clear vision.

Our Partner

Announcement

Collapse
No announcement yet.

Hid installation honda unicorn ???

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Hid installation honda unicorn ???

    Dear Friends
    HI
    I am suffering from unknown problem i will appreciate if you will help me.
    Two days before i mechanic has installed HID Xenon light in my bike the problem is that, only low beam is working although when i push the pass button the high beam works well but when i switch the light button from low beam to high beam the light goes off i am not understanding what is the problem.Your suggestions are valuable for me.
    Last edited by Aryan; 06-17-2010, 11:39 PM.
    Tags: None
  • #2
    Query Approved.
    :)

    Comment

    • #3
      Your relay or the wiring will be the culprit. The relay makes the motor move so your low will be focused to high.!!

      Comment

      • #4
        I think, your mechanic has forgot to convert the electrical system to full dc. The pass light runs on the DC. It may be when you press the pass button, the HID gets the the DC power and glows.Because the ballast need the DC power to operate.
        I may not be correct as I am not aware of the setup made by your mechanic. There can be a problem with the wiring also.
        I had this setups for few days. I connected the Halogen bulb as a high beam and the HID as a low beam(just changed the pin in the holder) - so, I can use the HID all the time.
        Move on.........
        bappaditya @ +919804822971.

        Comment

        • #5
          Need More suggestions .

          Comment

          • #6
            Had seen and solved the exact same problem on a friend's HH ZMAR. There is a diode in the wiring near the relay in the HID wiring harness.. When this diode blows the beam doesn't change.

            Comment

            • #7
              Thanks buddy i will try

              Comment

              Previous template Next
              Working...
              X
              © xBhp.com 2026. All rights reserved.
              Designed by xBhp