DIY request thread

[sunilg]

DIY request approved and merged.

[manubhat]

Hey guys,i was always fed up of frequent visits to svc for servicing my baby gixer(GS150R) as i had to book my service a week before(here in Bangalore) and wait each time..
So i want to do it myself.

Requesting for a DIY for carburretor cleaning,Air filter cleaning and chain removal and cleaning

[2strokerama]

Not a request but didnt know where to put this:

where and how do you DIYers dispose of your used engine oil, brake fluid etc? As these are toxic, do you use any sealed containers for them or just flush them down the drain and let the city corporation\sewage board deal with it?

[iamarj]

DIY Request to replace stock air filter with K&N Filter

Can someone share the DIY for changing the stock airfilter to aftermarket airfilters?

My ride is a 2006 Honda Unicorn and I'd like to change the filter to K&N.

Thanks in advance!
aRJun

[sunilg]

Here is one such thread

http://www.xbhp.com/talkies/do-yourself/21064-how-install-new-k-n-ba-2201-pulsar.html

[lakshit1914]

i want to konw from u guyz ..does the handle bar of karizma zmr fits to karizma (the old one)......if it does is there any D.I.Y for the same

[iamarj]

Conical Filters!

Can someone share the DIY for changing the stock airfilter to aftermarket airfilters?

My ride is a 2006 Honda Unicorn and I'd like to change the filter to K&N.

Thanks in advance!
aRJun

Got an answer from the post http://www.xbhp.com/talkies/do-yours...01-pulsar.html

But can someone provide a similar DIY for conical filters?? Pref Bikes: Unicorn/Pulsar!

[swift]

Replace brake pads in Drum brakes

Any DIY thread to replace drum brake pads? I cant find any while searching.

[art]

want any DIY for carb servicing..

[Aneesh@4GHz]

want any DIY for carb servicing..

Have a look at this DIY.

[girimajiananth]

DIY request

any one know how to change the speedo meter backlight for cbz extreme ?

[Sauravh]

Anyone has done tire hugger mod on R15 v1.

I assume that P135 hugger could be fitted as the tire profile is same.
I'm not able to source one to try myself; hence asking if anyone has done so already?

[christo]

Re: DIY request thread

Any DIY on tappet adjusting for fz16?

Sent from my WT19i using Tapatalk 2

[accuengineer]

Changing of Side indicator's in Yamaha FZ

Dear all
It might be a frustrating and annoying sight to see the side indicators hanging. Well in Yamaha FZ series the front side indicators(FSI) are designed well to absorb shock(i.e) it can bend and not break due to flexible rubber component being used. Where as the rear side indicator(RSI) is also made of rubber but is not as agile as the front side indicators. We can easily use FSI instead of the RSI. The only problem is the FSI is having short length cables. Just by adding more cable from the previous RSI, we can use the FSI. The advantages of FSI is that is it very good impact absorber.

P.S - If anyone wants a step by step procedure with photo it can be provided.

Mathews

[antz.bin]

Thread Approved and Merged