Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Axor
Magazine
Castrol Power 1

The slower the vehicle, the quicker it can turn.

Our Partner

Announcement

Collapse
No announcement yet.

Cold start issue with FSZ

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • #1

    Cold start issue with FSZ

    hey guys,
    just got my FZS 2 days back and i have a problem with cold start.

    even though i pull the CHOKE all the way down and the start the bike,the bike does not get started...even with the choke off.
    i have to Revive while pressing the elec. start button and then only the bike starts but after few seconds the engines dies!so i have to keep reviving for some time till the engines heats up!

    any help?
    am i doing anything wrong?

    thank you
    Smoke rubber,not tobacco.

    -Life Through-the-Lens
    -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!
    Tags: None
  • #2
    Query Approved.
    :)

    Comment

    • #3
      Change the slow speed of your carb. There is a screw to change the idling speed. Your engine is dying because your idling speed is very low.

      When idling make sure that the RPM is atleast 1000.
      "The trouble with the rat race is that even if you win, you're still a rat" - Lily Tomlin

      Comment

      • #4
        EDIT
        ok i tried starting right now!this is what happened!

        set IGNITION KEY to ON
        then FUEL to ON
        ENGINE SWITCH to ON
        CHOKE to ON
        tried starting...fail...tried around 6 times..including pressing for a while

        i then switched OFF the CHOKE and tried...on my 5th or 6th try the bike started,idling at 1000 but as soon as i switched CHOKE to ON,ENGINE FAILS,then it only starts with CHOKE OFF.

        what is going on guys?
        anyway ill got to YAMAHA tom!

        thank you
        Last edited by RanjithMN; 08-16-2009, 12:28 PM.
        Smoke rubber,not tobacco.

        -Life Through-the-Lens
        -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!

        Comment

        • #5
          choke is not to be turned on when engine running.. turn choke on before cranking the engine

          Comment

          • #6
            oh dint know that..thanks,so once the engine is started with the choke,should i OFF it immediately or after 30-40sec?
            anyway like i mentioned the bike was starting only with the choke off!
            btw is 1000 the idle RPM?
            thank you
            Smoke rubber,not tobacco.

            -Life Through-the-Lens
            -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!

            Comment

            • #7
              Here's a step-by-step guide:

              1. Start the bike (choke OFF)

              2. Ride around for about 5-10 km continuously to let the engine warm up a little.

              3. Shift down to NEUTRAL, stop the bike ( do not turn off the engine)

              4. Set the engine idle RPM to 1300-1500 by turning the engine RPM screw anti-clockwise to increase RPM, clockwise to decrease (might take some time to find the right settings).



              You're all set to go now
              Last edited by Sava; 08-16-2009, 10:16 PM.

              Comment

              • #8
                Originally posted by Sava View Post
                Here's a step-by-step guide:

                1. Start the bike (choke OFF)

                2. Ride around for about 5-10 km continuously to let the engine warm up a little.

                3. Shift down to NEUTRAL, stop the bike ( do not turn off the engine)

                4. Set the engine idle RPM to 1300-1500 by turning the engine RPM screw anti-clockwise to increase RPM, clockwise to decrease (might take some time to find the right settings).



                You're all set to go now
                detailed advice....follow it
                RIDE FAST, PLAY SAFE !!!

                Comment

                • #9
                  yep i was going through the manual on how to inc. the RPM,but once again..if every FZ idles at 1k and starts fine,shouldn't my do the same too?

                  thank you
                  Smoke rubber,not tobacco.

                  -Life Through-the-Lens
                  -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!

                  Comment

                  • #10
                    guys one Q,
                    when the engine is warm does the Bike switch off when you on the choke?
                    Smoke rubber,not tobacco.

                    -Life Through-the-Lens
                    -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!

                    Comment

                    • #11
                      Yes!!
                      It does

                      Comment

                      • #12
                        Originally posted by RanjithMN View Post
                        yep i was going through the manual on how to inc. the RPM,but once again..if every FZ idles at 1k and starts fine,shouldn't my do the same too?

                        thank you
                        Idle RPM varies from bike to bike. FZ's idle RPM should be 1300-1500 according to the manual. Check page 6-11
                        Last edited by Sava; 08-17-2009, 11:24 AM.

                        Comment

                        • #13
                          go to ASC and get the problem sorted out...dont set the idle speed urself..it should be set using calibrated machines....although setting by hand is OK....but dont do it....leave the job to professional....and since the bike is new..better not fiddle urself or else teh Service center guys will blame everything on u....


                          agree with sava....it should idle at 1300RPM or not below 1200RPM....
                          Last edited by princesirohi; 08-17-2009, 12:10 PM. Reason: jlt
                          sigpic

                          Tyre Sizes _ Spark Plugs

                          Headlight Focus _ Fork Oils

                          All India xBhp Couple Riders Thread

                          Ashtavinayak + Shirdi
                          Purandar
                          Raigad
                          Dapoli
                          Aurangabad
                          Kaas Plateu & Thoseghar Waterfalls
                          Purandar

                          Comment

                          • #14
                            I do had the same problem in my Kid for many days...
                            TVS SV was Cramp,....and after few Demnistrations i found this small Formula....

                            Cool Morning with night full of showers....
                            Bike Engine oil will sleep all the night....so the engine and its parts will be cool......
                            Take the bike....switch on Ignition.....
                            1 - Hold the Disc brake and pull the bike in front by sitting on the bike....so as you hear the fuel dance in the Tank....- this sill remove all the airlocks in Fuel tank and in Engine....
                            2 - Use the clutch lever for some 6-8 times ....
                            3 - Noe its your Choice i use kicker---since FZ doesnt have a kicker go for Self...
                            4 - Use chock and start the Bike.....and leave it for some 5 sec....thats it...Your Bike is started.....

                            This method has been tested with Flame...Uni...Stunner....P200....and worked

                            So this will work better in ur Babe tooo....Give a try...If the above is not working....then ur bike has been set for Lean mixture of Fuel....of some setting has to be set in Carb.....

                            Comment

                            • #15
                              thanx guys,
                              ok i went the the Service Center and they said the choke functiuon is alright and i think he inc. the RPM a little bit...the he asked me to jst sligtly rev when the bikes starts..

                              anyway ill check tom once more and ill try your method THUNDER!

                              thanks

                              btw another Q,off topic but don't want to start a new thread,every time i off the engine should i OFF the engine switch before turning the key to OFF?
                              @prince...corrected
                              Last edited by RanjithMN; 08-17-2009, 04:11 PM.
                              Smoke rubber,not tobacco.

                              -Life Through-the-Lens
                              -For HELLA/VALEO [BMW/AUDI/FORD/LINCOLN/SKODA],P220,Aftermarket Projectors,pls contact me!

                              Comment

                              Previous 1 2 template Next
                              Working...
                              X
                              © xBhp.com 2026. All rights reserved.
                              Designed by xBhp