Since '02 xBhp is different things to different people. From a close knit national community of
bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker
friends. Join us
If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I own a 2015 Pulsar RS200 , i can't turn on pilot lamp or console without starting engine .
i believe this can be fixed by doing a short circuit on relay .
we already have the steps for NS200 ( link below ) .
Re: Bajaj Pulsar RS 200 Owners Review and Experience
Hi Team ,
I own a 2015 Pulsar RS200 , i can't turn on pilot lamp or console without starting engine .
i believe this can be fixed by doing a short circuit on relay .
we already have the steps for NS200 ( link below ) .
2 mins is ideal. For cold mornings it all depends on the engine sound. With experience you'll understand how it sounds when cold vs warmed up. After warming up don't go crazy on the throttle though.
As a general rule I warm up the engine for at least 3 minutes in hot weather, and 5 minutes in cold weather. A good way to know if the engine is warm is to give a small blip of throttle and if the revs come back down smoothly, it's warm and ready to go, if it revs down slowly then it's still cold, give it a minute. Cheers.
Guys how much time is needed to warm up the machine (in mornings at neutral)??
2 mins is ideal. For cold mornings it all depends on the engine sound. With experience you'll understand how it sounds when cold vs warmed up. After warming up don't go crazy on the throttle though.
Guys how much time is needed to warm up the machine (in mornings at neutral)??
One to two mins is a good idle thumb rule. If your engine is hasn't started for more than two days, allowing the engine to idle for one to two mins, is a good idea before starting to ride the motorcycle.
Even I am facing this same issue,though I did not get the same code. Plz PM your mobile no. so I can send the same video to my service manager from the ASC , before he hooked the BOSCH diag tool to ecu, but that time no error code was showing, hence he dismissed it.
my vehicle problem is different as compared to yours, in yours the ecu detected fault since the engine light came on, visit svc and check the diagnostics again, itll show you the error code.
Leave a comment: