-
Right now my bike is running on pre-mix. It's a psychological feeling that I get from riding as if it has improved some initials.
Anyways, after doing about 100 kms or so, have taken a plug reading. Take a look at it and let me know if I need to adjust.Leave a comment:
-
Results? Arun, I'm having a tough time as...I don't know how to work on it!!! See my last few discussion with Yamdoot, I've no knowledge when it comes to these things
Leave a comment:
-
Yes the timing light clamp wire should be connected to the wire to spark plug cable from ignition coil. So what are the results Ganesh?Leave a comment:
-
The light will keep flickering but the rotor/ TDC mark should align well and appear stable. RDD install docs should give you some ideas. and the light need not be connected to the bikes wiring i believe.Leave a comment:
-
Yea yeah!!! I've done that using connector; but what I doubt is...Originally posted by yamdoot View Post
1. Where will the light flash constantly?
2. Does it keep flashing at one single point no matter how I hold the timing light OR should I hold in one specific position?
2a. If so what position?
3. Does the timing light really read the current from the ignition cap/wire?Leave a comment:
-
Yes. be sure to mark the TDC first.Originally posted by aargee View PostOk, ok ok...this helps me a lot
I see the light flickering. So stable light is the one I should be looking. No worries. I'll do that RIGHT TOMORROW & post the steps how to carry out here or may be as a DIY.
I'm determined to find the position man!!! Thanks for the encouragementLeave a comment:
-
Ok, ok ok...this helps me a lotOriginally posted by yamdoot View Post
I see the light flickering. So stable light is the one I should be looking. No worries. I'll do that RIGHT TOMORROW & post the steps how to carry out here or may be as a DIY.
I'm determined to find the position man!!! Thanks for the encouragement
Leave a comment:
-
Aw c'mon RG! no need for such words.. I need to try it myself soon too. Just looking for a cheap alternative. From what i have gathered, it shines intermittently and when shone on the moving rotor, it should appear stable if the timing is right. [Just like the moving ceiling fan appears still when you flicker a light on it or when you switch on the tube light].Originally posted by aargee View PostLeave a comment:
-
Arey it doesnt need an acount! just check!
BTW, how does your magnet show when you flash the gun on it?Leave a comment:
Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us
Always keep the chain well lubricated.
Our Partner
Leave a comment: