Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Axor
Magazine
Castrol Power 1

Always use both brakes to reduce speed.

Our Partner

Announcement

Collapse
No announcement yet.

Modified FZ16, FZ-S, Fazers owners Tech Talk

Collapse
X
Collapse
 
  • Page of 20
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 9 14 15 16 17 18 19 20 template Next
  • #271
    Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

    Originally posted by shv18 View Post
    Stock is 14 Front and Rear 40
    i'm not sure bro.. pls xheck this video
    My Tuning FZ - YouTube
    In this video its showing 15teeth front sprocket (old one)
    Last edited by manugmax; 07-24-2013, 07:00 PM.

    Comment

    • #272
      Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

      Originally posted by View Post
      i'm not sure bro.. pls xheck this video
      My Tuning FZ - YouTube
      In this video its showing 15teeth front sprocket (old one)

      Please check this simple DIY thread written by rider @Deville_56 http://www.xbhp.com/talkies/do-yours...et-change.html . Stock Yamaha FZ 16 comes with 14 T GB sprocket front and rear 40T.

      15T is a front sprocket mod to make the the gearing taller and higher top speed on FZ 16 at the cost of quick acceleration.

      Cheers,
      A quote by a toilet, " use me well, keep me clean, i would never tell anybody whatever i have seen.." :P

      Comment

      • #273
        Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

        guys i need help i have a fuel indicator issue even in full tank it shows zero fuel what should i do ??? should i replace the fuel sensor(SVC guys recommended) if yes then how??

        Comment

        • #274
          Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

          Originally posted by raj82q View Post
          guys i need help i have a fuel indicator issue even in full tank it shows zero fuel what should i do ??? should i replace the fuel sensor(SVC guys recommended) if yes then how??
          There is a one step simple solution to th fuel indiacator issue..even the Yamaha Factory shop's engineer (not the mechanic) advised me to do so...here it is:

          At the right side bottom of the fuel tank, if you see, there is a plug in joint (a small brass plug jointed to a wire)..that one is the sensor for fuel indicator..that sensor fails to work when it gets covered by dirt ..so please turn off ur ignition, wipe the joint well with a clean cloth (u may use some petrol /kerosene)...and again turn ON the ignition...it willl work fine....

          Comment

          • #275
            Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

            Can you please upload a pic since i cannot find it ????

            Comment

            • #276
              Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

              This is a post about My yamaha fz 16 modification into a very different duke 390 frontal looks .


              What i installed :

              ktm duke front tank cover

              ktm duke handle

              ktm duke headlight full assembly

              ktm duke visor + led indicators

              ktm sticker

              Paint.


              A metal tank specially designed with proper cuts to fit in fz along with the duke tank outside cover


              It was a very time taking job but it did paid well off . It cost around 12-14,000 to be precise . If anyone wants his bike to be modified can get in touch with me by mailing me on :- [email protected] or can even contact me on my fb page :- https://www.facebook.com/yash.naik.90


              It was great experience sharing with the xbhp'ians Click image for larger version Name: IMG_1096_1.jpg Views: 4 Size: 110.6 KB ID: 1887423

              Comment

              • #277
                Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                Hello anyone can help me out with these modifications?I want to install it but cant find it online anywhere,I am from mumbai(Kandivali) anyone can help me out with where can i buy these???Click image for larger version Name: 20120912_215731.jpg Views: 2 Size: 74.4 KB ID: 1931240Click image for larger version Name: 80509d1347546051-yamaha-fz-16-fz-s-20120912_215532.jpg Views: 3 Size: 84.7 KB ID: 1931241

                Comment

                • #278
                  Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                  Hello dears, can you please tell me about this mod (r15 v2 seat on FZs 2010)

                  1) is it comfortable...?
                  2) it will need any welding or cutting...?
                  3) expected price....?

                  This picture is not owned by me...
                  I don't know who is owner of this Horse...!

                  I got it from internet.....👌
                  Attached Files
                  Last edited by rbr; 06-23-2016, 09:07 PM.
                  rbr

                  Comment

                  • #279
                    Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                    Originally posted by Fazer89 View Post
                    Hi Guys,

                    I wonder even with such modifications none of the owners have been able to surpass 136 kmph. I know the time taken to reach that speed has reduced. But still we all need that top end. at least a 140 Kmph.
                    Wonder if that can be breached. Can any one help? Coz i am thinkin of getting a Bigbore & a 29carb from RaceConcepts.

                    Btw i already have a Leo Vince Exhaust and a Flat K&N Filter. Would the LV FFE support the 180 BigBore.

                    Mad Mik, Lucky Luke & Joel Joseph & other seniors if could help.

                    Regards,
                    Rohan
                    Can we play with sprockets, after big bore....
                    As i don't have knowledge about big bore or sproketing, i have learnt this from here (xbhp), i m just asking.....😉
                    rbr

                    Comment

                    • #280
                      Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                      Originally posted by sandy.avy220 View Post
                      [ATTACH]108880[/ATTACH][ATTACH]108881[/ATTACH]
                      Fz16 full faired.
                      Fairing from...(which bike)..?
                      rbr

                      Comment

                      • #281
                        Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                        My Yamaha Fazer had done 32k km within 2 year span. Now I am looking for a little mod. I heard a lot about Joel's Race Concept FFE and 180cc bore kit with simota air filter. I want to install that FFE only. Does it do any damage to the engine for the long run? Advice please!
                        Regards
                        Saikat

                        Comment

                        • #282
                          Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                          Originally posted by saikatbyte View Post
                          My Yamaha Fazer had done 32k km within 2 year span. Now I am looking for a little mod. I heard a lot about Joel's Race Concept FFE and 180cc bore kit with simota air filter. I want to install that FFE only. Does it do any damage to the engine for the long run? Advice please!
                          Avoid. Reliability is a big question.

                          The POWERHOUSE Fz18 - xBhp.com : The Global Indian Biking Community
                          http://www.xbhp.com/talkies/general-biking-discussion/23969-powerhouse-fz18.html
                          General Biking Discussions: Questions, complaints, concerns, rants & everything in between, of course related to biking.
                          #RetiredRider
                          #KeyboardWarrior

                          Comment

                          • #283
                            Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                            If you want to install a big bore kit you are asking for problems galore. Its not just about blotting a big bore kit on to the engine, but also about rebalancing the crankshaft, installing a bigger throttle body with revised jetting, a free flow exhaust and a reshaped combustion chamber head. This is a very high risk endeavour and if you do not have an appetite for taking risk its best that you do not go down this road.

                            Installing a free flow exhaust is less of a problem. However, even over there it needs to be done properly or else you will face problems after installation. If you are keen on the free flow exhaust then I would recommend that you go for a branded one. It is also highly recommended that you get your fueling sorted out by a knowledgeable tuner along with installing the free flow exhaust.

                            Do keep in mind that you are not going to get any dramatic increase in power, yes, you will get a sharper responding engine with about 1 to 2 bhp increase. So take a call based on cost vs. results analysis.


                            Originally posted by saikatbyte View Post
                            My Yamaha Fazer had done 32k km within 2 year span. Now I am looking for a little mod. I heard a lot about Joel's Race Concept FFE and 180cc bore kit with simota air filter. I want to install that FFE only. Does it do any damage to the engine for the long run? Advice please!
                            Only a biker knows why a dog sticks his head out of a car window.

                            Multum in Parvo - Much in Little

                            "Yes, it is FAST! No, you CAN'T ride it!" - http://www.xbhp.com/talkies/general-...a-300-san.html

                            Comment

                            • #284
                              Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                              Originally posted by abhimanyu31 View Post
                              Installing a free flow exhaust is less of a problem. However, even over there it needs to be done properly or else you will face problems after installation. If you are keen on the free flow exhaust then I would recommend that you go for a branded one. It is also highly recommended that you get your fueling sorted out by a knowledgeable tuner along with installing the free flow exhaust.
                              I know what you are trying to say. I heard about reliability issues after modifying bike, and I find them Olx too (modified fz etc etc). I dont want a nightmare after installing FFE and running on a empty road and suddenly bike stops due to mechanical fault. Thanks for your suggestion.
                              Regards
                              Saikat

                              Comment

                              • #285
                                Re: Modified FZ16, FZ-S, Fazers owners Tech Talk

                                Anyone had fitten NGK CPR8EAIX-9 Iridium Spark plug along with NGK/Splitfire Ignition Wire?
                                AFAIK Stock Ignition Coil assembly might not be suitable to fit into thr above ignition cable.
                                Suggest a suitable DIY method.
                                Thanks in advance.
                                Regards
                                Saikat

                                Comment

                                Previous 1 9 14 15 16 17 18 19 20 template Next
                                Working...
                                X
                                © xBhp.com 2026. All rights reserved.
                                Designed by xBhp