gladiator parts

Hi Prashant,
thanks for your support. I need to know if the following parts are available and the cost. The bike is Gladiator SS model 5YY
Block-Piston kit
Valves
Carburettor
Thanks

I would suggest you take ur carb to another mechanic and show it. The low pick up might not be a carb problem.

Was the whole change worth it? Does it need a 7ah battery to operate?? What about the recharging rate of the battery??

Ill try and look for the manual. Im not sure if its still on my old hard drive. If it is ill upload it.

service manual for Gladiator

Hi,
This link does not exist now. Can someone please provide the correct link. Thanks.

Hi, All,

I am in the process of resurecting my brother's 2006 Gladi. I have purchased some of the spares from Yamaha authorised spare outlets in Mapusa and Panjim, Goa. The details are as follows:

1) Brake pad kit Rs. 130, 2) Race bearing kit Rs. 294, 3) Shock oil Rs. 116, 4) Front shock dust seal Rs.92/pair, 5) choke cable Rs. 27, 6) Clutch cable Rs. 74, 7) Throttle cable Rs. 67, 8) Cylinder head gasket Rs. Rs. 95, 9) Gasket magnet side Rs. 20, 9) Gasket crank case Rs.34, 10) Rocker 'O' Ring Rs. 24/pair, 11) Spark Plug NGK CR7HSA Rs. 70, 12) Spark plug cap Rs. 70, 13) Rear brake shoe kit Rs. 250. These prices are inclusive of VAT. 14) Castrol 4T 20W50 oil ( 1 ltr ) Rs. 260. 15) Front shock oil seals are not available here, but managed to get look alikes for Rs. 175/pair. It was a rip-off.

Unfortunately, I kicked the bike and jammed the piston. ( I suspect there was water in the engine oil ). I have to open the engine but spares like oil seals are not available. Have to place an order for the same. A set of chain and sproket with Yamaha packing costs Rs. 1200.

Can any one on the fora help me in suggesting genuine spare dealers in Goa other than Yamaha outlets please.
Thanks

I have installed HID in my gladi 2006 model. I took my bike to bangalore for dc conversion. Ruby Electricals in bangalore do that. Then purchased HID from Navnish. You can find him in xbhp itself. Then installed HID in my bike. I changed my battery to exide 7ah. Costed total around 5000.

guys anyone from pune owning yamaha???? can anyone tell any good sc or good mechanic for yamaha?

First i noticed some sound in engine, then took the sc then they rectified it, that time they told carb needs to be replaced. Now there is no pickup at al in my bike. I will upload the image of bill by night!

First of all, 3400 is whopping bill. What have they replaced in your bike? Chain sprocket costs a bit, yes. Around 900 when i changed it. But spark plugs etc don cost much. And about the carburettor do consult another mechanic or SC. Do you find any problems while riding? I dont understand why they would need to replace one...

Yeah the clutch should be fine. I changed mine recently at around 39,000 kms. It was just a little hard so i decided to change. And i have not heard of that theory before. But i do not think there is too much truth in it.

Has run around 21K KM's. Hence I still feel clutch plate will be fine. Once I have heard a theory saying if the Odometer is reset to zero or changed to some other KM's, the speedometer needle starts to shiver and there is no way to change it. I don't believe it. Any views about this belief.

guys have some problem.. last week gave my gladi for service in yamaha factory shop in pune. the bill came to around 3400. they changed chain sprocket spark plug and other cables. but there was no pick up at al. then when i enquired with them they told carburettor needs to be replaced. costing around 4000. but as far as i know carburettor does not gets damaged for 23000kms. my bike is 5yrs old and clocked 23000kms. any advice on this guys.

can nebody give me a link for the ownership manual of gladiator/??
I need it desperately... Plz help..

Well. I do not know if a ladies side handle could be fitted to the gladiator. So i can not help you on that. How many kilometers has your gladi run? If you do not find your clutch plate to be excessively hard or clunky, I do not think its a problem with the clutch. The speedometer needle shivering will have to be fixed by giving it to a meter expert. Even mine used to shiver for sometime. For all you know, maybe a little greasing will be all it needs.

Glady

Hi,
I too have seen this happen to my brother's bike. Now that I have decided to resurect the Glady, I'm just thinkinking if it would be worth the money than purchasing a new bike......

Any views from Gladiator owners.?

Few queries about yamaha gladiator DLX 2006 model.Is there a possibility to fit a ladies or side handle(with a hook), kindly post the pic if anyone has done it. Also what could be wrong if the pickup in 2 gear is poor, could this be due to cluth plate or something else. One more problem noticed is that the speedometer needle shivers while going up , doesn't steadily increases when speeding up.

Thanks in advance.