Announcement

**rumailingme** · 08-23-2011, 10:32 AM

Originally posted by kinshuk.arya View Post

there are no such brand of angel eyes available all of them are chinese products. no guarantee for all of them.....

the charges of the AE should not be more than 400rs for a pair any colour....

while fitting the person should not cut anything or scratch anything apart for a very small hole required may be for the wire thats it. if he is doing any other cutting he is not doing properly...

Originally posted by rohan_5013 View Post

Either try Bi-Xenon Hid Kit, Bi-Xenon projector, Bi-Xenon headlights, Angel Eyes, Projector Headlights, Projector Headlights for R15, performance parts in delhi, projection headlamps in delhi, HID Projection in delhi, angel eyes headlights, angel eyes r15, gree
or
Angel eyes or Demons Eyes for all bikes, Indian & Imports - xBhp Classifieds : Buy & Sell

Both supposed to be reliable..cost not so sure but it is a bit expensive..2k+ i think
Also other members who have got it done can chip in..as I have not fitted these..yet

svc guys dont knw to fix AE so i must do it locally anywhere,they wont take care while doing so
i am not gonna take risk of spoiling at the beginnning itself.

ok guys i better not open my byk for atleast for 1st service.what you say?

or any trusted mech in chennai to do so with care for not spoiling the fairing? Bcs i wanted my byk to be looking gorgeous

when coming inside my streets..

**kauria** · 08-23-2011, 12:22 PM

Hi,
My FZs is only 2100 km old and its rear tyre already puncher twice. I brought the tyre repairing kit and patch the tyre myself. But I always feel that there is not adequate pressure in the rear tyre, though both the patches are ok and not licking air. There is no bend in the rim also.

I was thinking of putting Ninja IRC tyre (130/70 x 17) in my rear? Which is 10mm narrower then the stock one, do you guys think this will make any problem?

Any one tried this setup before?

KB

**eliksir** · 08-23-2011, 12:26 PM

did my fourth service at around 5800km . The usual oil change and chain maintenance plus a teflon coating. Now the engine and gearshifts are smoother than ever. Never felt this smooth, even on the first few days.

**kinshuk.arya** · 08-23-2011, 12:38 PM

Originally posted by kauria View Post

Hi,
My FZs is only 2100 km old and its rear tyre already puncher twice. I brought the tyre repairing kit and patch the tyre myself. But I always feel that there is not adequate pressure in the rear tyre, though both the patches are ok and not licking air. There is no bend in the rim also.

I was thinking of putting Ninja IRC tyre (130/70 x 17) in my rear? Which is 10mm narrower then the stock one, do you guys think this will make any problem?

Any one tried this setup before?

KB

Ninja's stock tyre is not considered good by the owners(hearsay).

I would suggest you to go to a petrol bunk and get the correct pressure(32psi) filled in the rear tyre and then monitor that pressure for a couple of days.

and then we can come to a conclusion that whether your rear tyre is actually lekaing air or not.

besides that 2100km is a very very short interval for changing the tyre. normally tyres can run fine upto 18-22k km depending on the type of usage.

**bikekrazy** · 08-23-2011, 04:14 PM

guys sorry for being a bit oT...
currently i am riding New Cbz..
i have Stock mrf tyres and usually drive 50 kms each day.
i used to measure my tyre air pressure every alternate day @ after every 100kms...but aalways found 4psi less than measured before.
would you like you suggest me something about this sceanario?

**Sunjay Kumar** · 08-23-2011, 04:26 PM

Guys i am planning to do a Teflon or polish or wax coat on my bike
i want to know the main differences in the 3 types
and the appproximate cost of doing it
which of the three will be better my bike is only 2.3k old so it is still shiny but the middle black part of the tank looks a bit dull sometimes
which of the 3 will be better for my bike and the cost of doing it

**kinshuk.arya** · 08-23-2011, 04:33 PM

Originally posted by Sunjay Kumar View Post

Guys i am planning to do a Teflon or polish or wax coat on my bike
i want to know the main differences in the 3 types
and the appproximate cost of doing it
which of the three will be better my bike is only 2.3k old so it is still shiny but the middle black part of the tank looks a bit dull sometimes
which of the 3 will be better for my bike and the cost of doing it

Teflon:

cost around 500rs for 3 coatings can be done at any service center.
each coating done after a couple of months
Polish or Wax:

both of them are same. just get a box of carnauba wax (cost varies from 150-320rs depending on the brand) from any of the accessory shop and do it yourself following the instructions. a box can be used for at least 8-9 coats on a bike.

for wax the time period is once or twice evry month.

i dont know how much effective is what.

have been using the wax polish from the past two years and 15k km. the bike is still shiny.

**Sunjay Kumar** · 08-23-2011, 04:37 PM

Originally posted by rumailingme View Post

svc guys dont knw to fix AE so i must do it locally anywhere,they wont take care while doing so
i am not gonna take risk of spoiling at the beginnning itself.

ok guys i better not open my byk for atleast for 1st service.what you say?

Its better not to do anything till the first service
dont worry man competition white fazer is a georgeous bike

will the first 1k up shift at 3k
and do not cross 4k in any gear
just have to controll your emotions till the 1k
i have heard that the new lot i mean the 2011 editions
have better fuel efficency
maintain correct air preassure fill it up with good quality fuel
dont rip till 1k

If you are sure that you will not cross 1k in 30 days then dont try to
its always better to have an early oil change in run in
if you get your bike serviced before 1k then continue the run in way of driving till 1k
go for the chain lube in 500kms

**Sunjay Kumar** · 08-23-2011, 04:40 PM

Originally posted by kinshuk.arya View Post

Teflon:

cost around 500rs for 3 coatings can be done at any service center.
each coating done after a couple of months
Polish or Wax:

both of them are same. just get a box of carnauba wax (cost varies from 150-320rs depending on the brand) from any of the accessory shop and do it yourself following the instructions. a box can be used for at least 8-9 coats on a bike.

for wax the time period is once or twice evry month.

i dont know how much effective is what.

have been using the wax polish from the past two years and 15k km. the bike is still shiny.

what is this wax polish is it something like a mix of both how much does it cost
which brand are you using
and the interval of coating it

**rumailingme** · 08-23-2011, 04:48 PM

Originally posted by Sunjay Kumar View Post

dont worry man competition white fazer is a georgeous bike

just have to controll your emotions till the 1k
i have heard that the new lot i mean the 2011 editions
have better fuel efficency

dont rip till 1k

If you are sure that you will not cross 1k in 30 days then dont try to
its always better to have an early oil change in run in
if you get your bike serviced before 1k then continue the run in way of driving till 1k
go for the chain lube in 500kms

Thanks dude.. for the points, i was thinking of shifting at 4-5 k but nw i will surely control my emotions

**kinshuk.arya** · 08-23-2011, 05:03 PM

Originally posted by Sunjay Kumar View Post

what is this wax polish is it something like a mix of both how much does it cost
which brand are you using
and the interval of coating it

see anything that makes something glow is called a polish like you used to use on your shoes in school and office etc. this thing is something one uses for car and bike bodies.

I am using a brand called Formula 1 it cost me 320rs for a box. you also get the applicator when you buy the box inside it itself. you can find it in any car accessory shop.

as i said before interval for wax polish is normally once or twice per month depending on the condition of the bike.

Originally posted by rumailingme View Post

Thanks dude.. for the points, i was thinking of shifting at 4-5 k but nw i will surely control my emotions

just control you emotions for a 1000km and after that let them go wild (off course if permitted by traffic and road condition)

**w00d@bangalore** · 08-23-2011, 05:11 PM

Originally posted by Sunjay Kumar View Post

Guys i am planning to do a Teflon or polish or wax coat on my bike
i want to know the main differences in the 3 types
and the appproximate cost of doing it
which of the three will be better my bike is only 2.3k old so it is still shiny but the middle black part of the tank looks a bit dull sometimes
which of the 3 will be better for my bike and the cost of doing it

Mine too man the middle black paint job is Sub standard at best but the red is LAVA still

My thing is wait 4 a while before the teflon its still rainy season

Originally posted by rumailingme View Post

Thanks dude.. for the points, i was thinking of shifting at 4-5 k but nw i will surely control my emotions

Just 4 the heck of it do it once just open that throttle to the full n have fun
dont go 4 long ride if i might add but just do it n have that guilty pleasure

rumailingme I was EXPECTING some nice Pics from u say what?

**rumailingme** · 08-23-2011, 05:12 PM

my friend and me planned to buy/make a engine scoop for preventing mud and sand from getting caught in middle of those segmented engine walls.

is a engine scoop advised ? since it is a air-cooled one.

**blacklist3** · 08-23-2011, 06:32 PM

Guys FZ club in facebook.......pour in

Yamaha FZ/Fazer Owner's Club (INDIA) | Facebook

https://www.facebook.com/groups/fz16riders/

A place to gather for those who rides the YAMAHA FZ/Fazer series of motorcycles. If you own or plan to own an FZ/Fazer-16 or FZ/Fazer-s or FZ V 2.0 or even the FZ-25. This is your place to be....

**kinshuk.arya** · 08-23-2011, 06:48 PM

Originally posted by rumailingme View Post

my friend and me planned to buy/make a engine scoop for preventing mud and sand from getting caught in middle of those segmented engine walls.

is a engine scoop advised ? since it is a air-cooled one.

there is an engine belly made by dnovo in pune search for dnovo engine belly on ebay you will find one...

Announcement

Yamaha FZ-16/ FZ-S

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment