Announcement
Collapse
No announcement yet.
Benelli TNT 300 Ownership Experience
Collapse
X
-
Re: Benelli TNT 300 Ownership Experience
This Saturday, I got my Temperature sensor replaced from the Domlur SVC as radiator fan was spinning as soon as I was turning the ignition key on. Though the issue occurred only for a day, I did not take chances and got it replaced under warranty.Owned - Yamaha RX100 -> TVS Fiero F2 -> Yamaha R15 -> KTM RC390
Comment
-
-
Benelli TNT 300 Ownership Experience
Prabhat Tyre’sOriginally posted by mandarr View PostFolks,
Please suggest a reasonable Tyre Dealer in Pune, need to replace both the tyres of my tnt300i.
Service centre don't do tyres unfortunately.
Dealer name and contact number will help.
9890189089
9921944069
I got my TNT 300 tyres replaced here.
Last edited by cgowda; 12-18-2019, 01:40 PM.
Comment
-
Re: Benelli TNT 300 Ownership Experience
I am facing similar issue.. Hope you found the solution.. I will try to change the clutch cable initially if it persists its probably clutch plate or something thats damaged
Originally posted by samhassan View PostHello guys..its been a long time..hope u all doing good, right now iam facing a problem and just to intimate that i have done my 25,000k km service last week, once after the service my gear is too hard and i thought its usual, but it wasn't like a normal thing since i started to notice that I couldn't be able to engage to the first gear when the bike is dead slow or stalled, and also iam getting a lame or false gear shifts over shifting from second to third and fourth gear. Does anyone experienced the same thing before??can anyone help me out with the issue?
Comment
-
Re: Benelli TNT 300 Ownership Experience
hi guys, I adjust my clutch lever clearance by adjusting the bottom nut, I think I f**ked it up, may be sensor or something, now no matter low or high clearance, the engine will stall as soon as I put into 1st gear! without even releasing the clutch...
these are my positions.... please help? thank you!

Comment
-
Re: Benelli TNT 300 Ownership Experience
Looks like the sidestand switch is stuck. Just check if it is released properly.
The issue that you explained here happens when the bike is on side stand and we engage the gear.Looks like the sidestand switch is stuck. Just check if it is released properly.Originally posted by nathan_ooi View Posthi guys, I adjust my clutch lever clearance by adjusting the bottom nut, I think I f**ked it up, may be sensor or something, now no matter low or high clearance, the engine will stall as soon as I put into 1st gear! without even releasing the clutch...
these are my positions.... please help? thank you!


The issue that you explained here happens when the bike is on side stand and we engage the gear.
Comment
-
Re: Benelli TNT 300 Ownership Experience
EXide BVTZ9Originally posted by umang75 View PostLooking for a replacement battery for tnt300 2016 model. Kindly guide.
Comment



Comment