Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Castrol Power 1

Check engine oil level before every ride.

Our Partner

Announcement

Collapse
No announcement yet.

TVS Apache RTR 180

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Originally posted by psr View Post
    Using Petrol to clean Air Filter will clean better..using Kerosene you have to soak and wait for 5 minutes,and then squeeze it dry,and repeat it 4 or 5 times.
    If you use Petrol you have to wait till it dries fully,because Petrol vapor is highly explosive and if mounted back into engine,when wet,will make the AF ratio rich and if it backfires will catch fire.....So Kerosene is better.
    After cleaning,use FRESH light engine oil of 20 or 30 grade to make the air filter wet,and Squeeze to let excess flow out.Now you mount the air filter in its place...and you have done a D I Y air filter cleaning and fitment..Revving the bike without airfilter for short duration is OK.But should not be for long....say more than5 to10 minutes is not good..
    When it backfires will fire from Exhaust ??? then it would look cool for some time
    site:xbhp.com keyword -> Google this to dig up stuff in xbhp faster

    Comment


    • Originally posted by social View Post
      Can the a/f mixture affect the engine vibes? Does a leaner mix make the engine work harder and hence produce a little bit more vibes compared to optimal/richer mixture.
      I suspect my bike is running lean. I rode a friend's bike and his was way smoother and also pick up in each gear was better. The engine revved very easily compared to mine. And the vibes were very less.
      Air fuel ratio has NOTHING to do with the vibes.

      The friends bike felt smooth because it might had cleaner air filter, much better lubed chain, slack in the chain to the right level, play in the clutch to the right level, road, pressure of the air in the tires etc.

      Originally posted by dead_piper View Post
      but when it started there was loads of black smoke coming from exhaust.
      Get your piston rings checked.
      Your bike is surely burning oil.

      Originally posted by psr View Post
      Black smoke is Excess fuel getting burnt...
      NO.

      Originally posted by social View Post
      But my bike never starts with the choke on at least with the kick. It barely manages to start with the electric starter.
      As winters are approaching, richen the mixture by jalf turns and all your starting troubles will be solved.


      Originally posted by dead_piper View Post
      helllllllllllllp., GUYS today whenever i started my bike there was smoke n even when i rev hard its coming., what could be the problem??? can rich mixture setting be the prob?
      this problem first started 2 days ago when i started bike after a couple of days rest n cold atmosphere.,
      Replied above.

      Originally posted by psr View Post
      Yes leaner AFR will make the engine vibrate more.
      NO, NEVER.

      Originally posted by psr View Post
      Setting AFR ,a little on the rich side is always better.
      YES.

      Originally posted by psr View Post
      Every early morning start with choke will produce slight smoke initially.
      NO.

      Originally posted by psr View Post
      Bikes with auto choke will work better than Manual choke
      Manual chaoke is always better than the auto choke, cuz over to the period of time, the sensor gets mind of its own in auto choke and forgets to switch the thing off !

      happened many times in my Scooty pep, i removed it.

      Originally posted by dead_piper View Post
      @psr:
      checked spark plug., it has carbon deposit and no oily feeling...
      Crisp brown burnt kinda color indicates perfect setting.


      Originally posted by naveen2cool View Post

      The mechanic there says that my rear disc is worn out
      Post the pic of your disc.

      Originally posted by social View Post

      And revving the bike with no air filter is a strict no no.
      The bike can be revved from morning till night without the air filter in an clean environment.

      It will make the throttle ultra crisp while making the bike sounding more deep at the same time.

      Originally posted by psr View Post
      if it backfires will catch fire..
      No, it wont catch fire, it wont let the exhaust to throw flames.
      The Magician"

      Comment


      • [QUOTE=rennycornelius;526245]Air fuel ratio has NOTHING to do with the vibes.


        It does renny. I have made trials with it. Running lean results in more vibrations, as the ignition is not uniform. This characteristic is more dominant in single cylinders and even stronger in oversquares.
        There's lot to it other than saddle....


        sigpic

        Comment


        • Originally posted by psr View Post
          From what you say it sounds like your fork yoke stems need lubrication..Does your bike stand in the open and get wet ?Go to your A.S.S since your bike is still under warranty and make a specific complaint,and they will rectify it for you.

          Thank you

          My first servicing is almost up.....I will ask them to do accordingly

          cheers

          Comment


          • even my bike has some problem with rear disk, my bike is only 4mnths - 4500kms old and i hear screech sound from rear wheel, and the break is also very weak.. i'm managing with the front break now...

            Comment


            • Originally posted by nox2505 View Post
              It does renny. I have made trials with it. Running lean results in more vibrations, as the ignition is not uniform. This characteristic is more dominant in single cylinders and even stronger in oversquares.
              I have never experienced it in my FIERO and KB100 (which used to vibrate a lot too, at par with RTR).

              Never had a chance to play with the settings of RTR.
              But with already so much Vibes at certain RPM, i fail to get any siolution for it.
              The Magician"

              Comment


              • Originally posted by thmh201 View Post
                even my bike has some problem with rear disk, my bike is only 4mnths - 4500kms old and i hear screech sound from rear wheel, and the break is also very weak.. i'm managing with the front break now...
                I have read in other forums of this happening.In fact the rear disk was worn out within 8 K kms in one case,and the owner had to change disk and pads to-gether. He was told that the rear caliper oil canister was empty,and the brake had held continuously,without pressure for braking..This had worn out both the disk and pads.The owner was asked to pay 2,500/-...Please make a SPECIFIC WRITTEN COMPLAINT to your A.S.S on this.and get it attended.The disc should not bind and wheel should rotate with little friction only.
                Last edited by psr; 11-11-2010, 09:42 PM.
                When Was The Last Time,You Did Something For The First Time.

                Comment


                • i had a small accident..slight scratch on the headlight!and my bike isnt even a week old!! planning to put stickers to cover it up or is there anyway to adda tpugh up?? my bike is still in run in period and one of my friends ripped the bike to 105! is this okay? or is it going to spoil my engine and what speed should i maintain?i am maintaining about 55 kmh max sometimes i go upto 60 is this okay, but i try to keep my bike below 4 RPM...i am experiencing large amout of vibes at 48-55 kmh will these reduce after first service??? also the engine gets hot very quickly is this beacuse this is a new bike???

                  Comment


                  • Renny thanks for taking the time to respond to the many queries. I had tried to explain based on my personal experience and of some of my friends..
                    1.Lean AFR had caused engine vibes in my Honda CX 125 twin(Now not with me),and also in my KB which I presently own.
                    2.Engine back fire has two circuits.One through the Exhaust,and the other through the intake manifold.Many have experienced the Exhaust one,and only a few have experienced the inlet type.Lean mix,and bad Valve timings(sometimes sticky valves) are the main reasons for it.
                    3. Temporary black smoke at the time of starting,with choke,is attributed to rich mix. I was explaining to a specific query .
                    4. In Petrol Vehicles, If rings are bad or if there is oil coming into the combustion chamber and getting burnt,the smoke from the Exhaust will be Blueish ...and there will be oily deposit at the Exit mouth of the Exhaust.

                    Just sharing what I have learnt till now..
                    When Was The Last Time,You Did Something For The First Time.

                    Comment


                    • Originally posted by kantu View Post
                      When it backfires will fire from Exhaust ??? then it would look cool for some time
                      Inlet back fire will blow out carb and air filter
                      When Was The Last Time,You Did Something For The First Time.

                      Comment


                      • Originally posted by pranav_salieri View Post
                        i had a small accident..slight scratch on the headlight!and my bike isnt even a week old!! planning to put stickers to cover it up or is there anyway to adda tpugh up?? my bike is still in run in period and one of my friends ripped the bike to 105! is this okay? or is it going to spoil my engine and what speed should i maintain?i am maintaining about 55 kmh max sometimes i go upto 60 is this okay, but i try to keep my bike below 4 RPM...i am experiencing large amout of vibes at 48-55 kmh will these reduce after first service??? also the engine gets hot very quickly is this beacuse this is a new bike???
                        Any high RPM running during engine setting time is not good for the engine.If the ripping had been very short time ..say for just passing another vehicle,and then slowing down then nothing to worry.Normally the setting in is done with respect to engine RPM IN ANY GEAR...which is 4,000 RPM.A new engine will get hot as its internals are rough and have not become smooth...which is why the 4 K rpm limit is mentioned.
                        Remember to mention the Vibration problem at the time you give the bike for servicing to A.S.S.
                        When Was The Last Time,You Did Something For The First Time.

                        Comment


                        • Originally posted by rennycornelius View Post
                          I have never experienced it in my FIERO and KB100 (which used to vibrate a lot too, at par with RTR).

                          Never had a chance to play with the settings of RTR.
                          But with already so much Vibes at certain RPM, i fail to get any siolution for it.
                          Renny elsewhere in another post I read that there are engine anchor bolts near the engine(small) sprocket which should be tightened for decreasing the Vibrations.It seems most of the RTR engine anchor nuts work loose due to vibes and need to be tightened periodically....Since I don't own a RTR I am unable to authenticate this statement.But I guess it is worth looking into.RTR Fi is supposed to have the least vibes of all the models.Since you own one ,what is your opinion....I am planning on buying a Apache 150 and upgrade to 180..so your input will be useful for me.
                          When Was The Last Time,You Did Something For The First Time.

                          Comment


                          • Originally posted by psr View Post

                            Lean AFR had caused engine vibes in my Honda CX 125 twin(Now not with me),and also in my KB which I presently own.

                            Why you sold it ??!!!!
                            And good to knw another KB100 owner, it's indeed a great bike !

                            I never experienced the vibes slowing down in the KB100, but that was my experience, and i would like to add that the KB100 has the most responsive carb i ever came across.

                            Engine back fire has two circuits.One through the Exhaust,and the other through the intake manifold.Many have experienced the Exhaust one,and only a few have experienced the inlet type.Lean mix,and bad Valve timings(sometimes sticky valves) are the main reasons for it.

                            I thought Back "fire" you're talkin about, RTR backfires a lot but it was FIERO which was the backfire champ...

                            Temporary black smoke at the time of starting,with choke,is attributed to rich mix. I was explaining to a specific query .

                            I never experienced it.
                            ..........Bolds.
                            The Magician"

                            Comment


                            • Originally posted by psr View Post
                              Renny elsewhere in another post I read that there are engine anchor bolts near the engine(small) sprocket which should be tightened for decreasing the Vibrations.It seems most of the RTR engine anchor nuts work loose due to vibes and need to be tightened periodically....Since I don't own a RTR I am unable to authenticate this statement.But I guess it is worth looking into.RTR Fi is supposed to have the least vibes of all the models.Since you own one ,what is your opinion....I am planning on buying a Apache 150 and upgrade to 180..so your input will be useful for me.
                              RTR's vibes is in diff league !
                              i tried all, tightened things here and there but no vail.

                              FI vibrates as same as RTR carbed, may be more, it vibrates like hell between 5200-6800, and then after 7000 RPM the pillion refuses to keep his feet on the pegs.

                              I will strongly advise you to buy 180 directly !
                              The Magician"

                              Comment


                              • Originally posted by rennycornelius View Post
                                ..........Bolds.
                                The honda parts were tough to get..The KB is still with me..and even recently did a total engine revival for it. I also had a Honda MVX 250..A three cylinder " V" 250 cc engine. The Bike never had vibration in any RPM and you had to look at the rpm and speedo to know how fast you are.It had 6 gears,and in the sixth at 1,600 RPM it will do 60 Kmph.In just 500 mts distance in city I had done 120 Kmph.(80's when traffic was very less).Even in highway it will go effortlessly to 140Kmph...Why I sold it ? It gave 15 Kms per liter,and parts were very hard to source,and the forward inclined riding position gave me back stiffness.
                                When Was The Last Time,You Did Something For The First Time.

                                Comment

                                Working...
                                X