Announcement

**plasmabhai** · 01-23-2014, 03:20 PM

Re: Honda Unicorn Dazzler

[MENTION=31946]amitmalve[/MENTION] Great mod amit..!! Looking great! Just couldn't help thinking that this colour scheme will look super cool on the silver dazzler!

Do let us know the details (like shailesh asked) about cost, adjustment that had to be made etc. For example did you have to fabricate a clamp for the rear brake fluid reservoir?

Also I upgraded to a 120/80-17 tyre - the super cool looking MRF Zapper Vyde

This what that looks like ->

Absolutely no modifications had to be made, there was no problem in fitting the tyre back either. There are no clearance issues anywhere either.

Ride height has increased slightly but noticeably. And the increased circumference has added about 2kmph to the speed of the bike for a given rpm. 5th gear @ 3000 rpms has increased from 40 kmph to 42kmph. 5th gear @ 4000 rpms has increased from 53 kmph to 55 kmph.

Also, if there is any increase in weight then I have as yet not noticed it, no sluggishness in acceleration due to weight. All in all a happy upgrade.

p.s. My stock tyre was shot after 23000 kms. It had a total of 5 punctures with 1 being plugged, 2 being plugged by nail and 2 small but open punctures. I was running this puncture combo for the last 3000 kms. Pressure would stabilize at 16 psi and would not decrease further so I just ran with it. Needless to say the handling has vastly improved over what I was riding for the last 3000 kms :P

Attached Files

**amitmalve** · 01-23-2014, 06:53 PM

Re: Honda Unicorn Dazzler

Originally posted by plasmabhai View Post

@amitmalve Great mod amit..!! Looking great! Just couldn't help thinking that this colour scheme will look super cool on the silver dazzler!

Do let us know the details (like shailesh asked) about cost, adjustment that had to be made etc. For example did you have to fabricate a clamp for the rear brake fluid reservoir?

Very soon I will post all the details of this mod. Till then, let me tell you all that it is not a very complicated installation process nor does it requires any major modifications. Only some adjustments are required & that too only on RHS (brake pedal & silencer side). Otherwise LHS side (gear shifter side) is almost a plug & play. Now I am very happy with this riding position.(I have already installed hh hunks handlebar which is slightly shorter than the stock one.) No, there was no need to fabricate any kinda clamp for rear brake fluid reservoir. It is at its stock position only. I have also planned to get those silver brackets painted in black.(may be a DIY like you did on your bike's silencer panels)

**neil9381** · 01-23-2014, 07:52 PM

Re: Honda Unicorn Dazzler

Today While riding,suddenly the battery went off(blank digital console) with total loss of power
What went wrong????
Anyone faced this problem??
The bike started when i switched off and then On the ignition while the bike was in motion.

**nadz11.ns** · 01-23-2014, 08:15 PM

Re: Honda Unicorn Dazzler

Originally posted by neil9381 View Post

Today While riding,suddenly the battery went off(blank digital console) with total loss of power
What went wrong????
Anyone faced this problem??
The bike started when i switched off and then On the ignition while the bike was in motion.

Are the electricals working now ?
Check the fuse and the battery terminals.

**Divya Sharan** · 01-23-2014, 09:40 PM

Re: Honda Unicorn Dazzler

Originally posted by neil9381 View Post

Today While riding,suddenly the battery went off(blank digital console) with total loss of power
What went wrong????
Anyone faced this problem??
The bike started when i switched off and then On the ignition while the bike was in motion.

Did you use the head lamp without starting the bike for long period of time recently? Starting issues are different, but yours happened while riding.

Did it restart later? Since the console went blank, it can't be air lock or fueling issue.

**plasmabhai** · 01-23-2014, 09:51 PM

Re: Honda Unicorn Dazzler

Originally posted by neil9381 View Post

Today While riding,suddenly the battery went off(blank digital console) with total loss of power
What went wrong????
Anyone faced this problem??
The bike started when i switched off and then On the ignition while the bike was in motion.

If otherwise your battery has enough juice (no starting troubles) then this may be something as simple as an issue of connection.

Most probably the connector of your console which lives inside the front headlight assembly might have come loose due to a bump. Simply reconnecting it firmly will solve your problem if it reoccurs.

This had happened to me once when I was standing at a signal. But like you did, I turned off and turned on the ignition and everything was back to normal and that problem has never repeated itself ever again.
[MENTION=31946]amitmalve[/MENTION] awesome! waiting for the details. A matt black look will go killer with the armor gold that our dazzler sport!

If you are going the DIY route then ping me for any query!

**sibun** · 01-23-2014, 11:47 PM

Re: Honda Unicorn Dazzler

Originally posted by vjxm View Post

i have done my bike's engine minor repair work.when i open head assembly there was lot of carbon deposit on Piston & Inlet Valve(also in inlet valve gallery of Head )i observe the Rings that there was little gap in ring's both ends when i place it in Cylinder, so i decide to continue with these rings.i have change valve seal, valve seat repair.now it don't show bluish white smoke any time till now, but there is a issue with starting in morning.my idling is 1300-1400 RPM1) it always start with choke(never mind) in cold morning.but after 23 minutes of starting when i try to move in 1 st gear it goes to die(no changes in tuning of Carburetor ) my doubt ,valves was tight, but that was fine, i inspect valve clearance (As it idling goes to 600 RPM when i try to down idling)2) i throttle it high in neutral (4000-5000 RPM) & leave accelerator it rpm down very slowly(take some time 3-4 Seconds)3) after some 5-6 Kms Ride when i stop the bike @ office (not engine) RPM goes down to 800 RPM but after a moment it idle normal 1300-1400 RPM. [ATTACH]132659[/ATTACH][ATTACH]132660[/ATTACH][ATTACH]132661[/ATTACH][ATTACH]132662[/ATTACH]sent from SGS3 by vjxm

Your bike is running rich. The reason for this is that when your bike had more carbon your bikes compression ratio was more as a result when the bike was tuned with carbon it was set with the increased compression.After removing the carbon the compression ratio changed and thus the mixture which was good before is now rich. So re=tune the carburettor and everything will be all right.

**pratik261** · 01-24-2014, 12:17 PM

Re: Honda Unicorn Dazzler

Originally posted by amitmalve View Post

Finally much needed rear-sets mod for Dazzler

Great mod!
Does it affect the smoothness while shifting gears? Just asking.

Sent from my LT22i using xBhp Connect mobile app

**abkumar** · 01-25-2014, 11:41 AM

Re: Honda Unicorn Dazzler

Just changed my engine oil to Motul 7100 10w40 Fully Synthetic. Per the dealer this should last 3.5k-4k kms. the engine have no major noticeable improvements in vibrations or smoothness.

**shail016** · 01-25-2014, 09:12 PM

Re: Honda Unicorn Dazzler

Hi All,

Today I started efforts towards my bike's repair. (you can find her sad state below)

I was unable to source below parts from honda in my local area.(as expected)
1. Console case (cost unknown)
2. Front fairing ( actually headlight casing)(cost unknown)
3. front Mudguard (confirmed Rs 780)

The Honda parts guy took 30mins to scan records and confirm that the part was unavailable(that I could have told him also

) and costs Rs780
For other two he straightforwardly said NO.

Anyhow I took bike to a local shop near my residence and got things fixed(partially in absence of replacement parts)
It took INR 1230 (funny figure) for straightening front forks, new cone set and miscellaneous work.

There were even lower quotes present for repair(as low as Rs350 for only forks straightening) but I preferred this guy as he works near my residence and helps me with normal adjustments mostly for no cost

and I can go to him any time I want.

took a quite long test ride and every thing worked perfectly (except vibrations and rattling due to damaged parts)

--
Regards,
Shail016

**vjxm** · 01-29-2014, 09:23 PM

Re: Honda Unicorn Dazzler

rear tyre throw water/muds on pillion foot.
front tyre also on rider foot.

is it possible to fix this problem

sent from SGS3 by vjxm

**shail016** · 02-22-2014, 06:50 PM

Re: Honda Unicorn Dazzler

Hi All, I have replaced some parts in my bike. please find the part info below.

PART_NAME (description)	PART_NO	COST (inclusive of vat 13.13%)
1) Cowl Front Right side (headlight right side body portion)	61032-KSP-B00ZA	RS 159
2) Meter cover (Front visor of headlight)	61300-KSP-B00ZA	Rs 235
3) Front Fender (Front mud guard)	6110-KSP-B00ZA	Rs 759
4) Front Fender Stay (a small metal strip to hold fender between forks)\|	61102-KSP-B00	Rs 46
5) Cowl Center (entire headlight casing)	61301-KSP-B00ZA	Rs 373
6) Disk pad front	16435-KSP-B01	Rs 430.28
7) Disk pad rear	06455-KPP-N01	Rs 836.39
8) Labor for both diskpad change	-	Rs 283

Hope it helps in some way.

**manas34** · 02-22-2014, 07:19 PM

Re: Honda Unicorn Dazzler

Is headlight casing of dazzler or trigger?

**abkumar** · 02-26-2014, 01:23 PM

Re: Honda Unicorn Dazzler

Can someone give an idea of the cost of chain sprocket set of Honda Unicorn Dazzler? This is kind a urgent please

**Divya Sharan** · 02-26-2014, 02:43 PM

Re: Honda Unicorn Dazzler

Originally posted by abkumar View Post

Can someone give an idea of the cost of chain sprocket set of Honda Unicorn Dazzler? This is kind a urgent please

2 prices, I guess the higher one is the latest price.

1800 + labor - http://www.xbhp.com/talkies/motorcyc...tml#post965964

1200 + labor - http://www.xbhp.com/talkies/help-me/...tml#post848979

Announcement

Honda Unicorn Dazzler

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment

Comment