Since '02 xBhp is different things to different people. From a close knit national community of bikers to India's only motorcycling lifestyle magazine and a place to make like-minded biker friends. Join us

Axor
Magazine
Castrol Power 1

Check the helmet from inside.

Our Partner

Announcement

Collapse
No announcement yet.

TVS Apache RTR 180

Collapse
X
Collapse
 
  • Page of 1,275
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 133 183 223 228 229 230 231 232 233 234 235 236 237 238 243 283 333 733 1233 1275 template Next
  • #3481
    Originally posted by theguitarfreak View Post
    Doesnt blipping the throttle consume more fuel? Because you are using the throttle more. I dont know. Just asking
    Slightly more, it'll dent the economy by overall of 2-3kmpl, but it'll smoothen the shifts like anything.

    Originally posted by Hyperion View Post
    How will throttle-blipping smoothen the gear shifts? Blipping the throttle will ensure that your engine speed matches the road speed as close as possible. This helps,

    1. Resist rear wheel lockups.
    2. Keeps you bikes flow smooth. You will appreciate this if you downshift when cornering. If you dont blip your throttle, you will feel your bike's balance is upset.

    Are you disengaging the clutch completely when shifting? Try to roll off the throttle completely when shifting. Also check the clutch lever play.
    Blipping the throttle or matching the revs technique smoothnes out the shifts, as it takes the lower gear close to the current RPM of the engine.

    Just before the turn downshifting is not recommended,(just cuz of the fear of the wheel lockup) always get into the correct gear atleast 10 meters before the lean.


    Originally posted by theguitarfreak View Post
    Yes they did ride my bike and concluded about the clutch plate. Earlier the bike used to be smooth after 5k. But not now. The vibes are there across the full rev range right from 4k.
    If you're not into wheelies and burnouts you just cannot fcuk the clutch at 8800kms..
    And like i always say- "lend the last surviving ear to the dumb SC guy"

    pull the bike to 8000RPM in 2 gear engage 3 while depressing clutch fully and if the bike revs first then surges forward (gap of a sec or so) your plates are gone, and if it just gives you a bang at the upshift like the RTR gives, your plates are perfectly fine.
    The Magician"

    Comment

    • #3482
      @ALL:

      All the guys who are facing hiccups problems in their respective bikes get your diaphram's spring checked, it might be the culprit.

      Also get the diaphram checked for currect fitment, around the circumfrence.
      The Magician"

      Comment

      • #3483
        Originally posted by Puneet1 View Post
        thats quite a high rate to repair a puncture . you can buy the whole repait kit for 230 RS that can fix 10 punctures.
        Can somebody tell me where in Bangalore can I buy that kit?

        Comment

        • #3484
          Originally posted by rennycornelius View Post

          Blipping the throttle or matching the revs technique smoothnes out the shifts, as it takes the lower gear close to the current RPM of the engine.

          Just before the turn downshifting is not recommended,(just cuz of the fear of the wheel lockup) always get into the correct gear atleast 10 meters before the lean.
          You mean shifting (up or down) into a corner is not recommended. I wasnt saying that either. I said when entering a corner.

          Comment

          • #3485
            Originally posted by amar_r15 View Post
            Hitting lower speeds at same rpm means ur clutch is slipping
            So that makes the clutch plate the culprit isnt it?

            Originally posted by rennycornelius View Post
            If you're not into wheelies and burnouts you just cannot fcuk the clutch at 8800kms..
            And like i always say- "lend the last surviving ear to the dumb SC guy"

            pull the bike to 8000RPM in 2 gear engage 3 while depressing clutch fully and if the bike revs first then surges forward (gap of a sec or so) your plates are gone, and if it just gives you a bang at the upshift like the RTR gives, your plates are perfectly fine.
            I will try that out. Can it be that the clutch plates are ok but the pressure plate is the culprit?
            You can only ride better tomorrow if you ride safe today.

            Comment

            • #3486
              Originally posted by Hyperion View Post
              You mean shifting (up or down) into a corner is not recommended. I wasnt saying that either. I said when entering a corner.
              Yup....

              Originally posted by theguitarfreak View Post
              I will try that out. Can it be that the clutch plates are ok but the pressure plate is the culprit?
              it will give out the same symptoms like i said, and if the pressure plates are gone you have to replace it with the clutch plates, but take my word for it, they are perfectly fine.
              The Magician"

              Comment

              • #3487
                Originally posted by rennycornelius View Post
                it will give out the same symptoms like i said, and if the pressure plates are gone you have to replace it with the clutch plates, but take my word for it, they are perfectly fine.
                Then why the vibrations which were non existent before above 5k?
                You can only ride better tomorrow if you ride safe today.

                Comment

                • #3488
                  Originally posted by theguitarfreak View Post
                  Then why the vibrations which were non existent before above 5k?
                  A worn out cutch plate will give you "juddring" not vibrations.
                  Vibrations are the part of the RTR mill, may be these are the one's waiting to get "errupted" at 5000RPM.
                  The Magician"

                  Comment

                  • #3489
                    Originally posted by rennycornelius View Post
                    +1.
                    He got so pissed of with the carb issues of the 220 that he sold it off.
                    Satish is the only p220 ian in the xbhp to have a carb problem,no one hasn't faced such a problem yet
                    A LOST RACE IS ALWAYS BETTER THAN A LOST LIMB

                    Comment

                    • #3490
                      Originally posted by rennycornelius View Post
                      @ALL:

                      All the guys who are facing hiccups problems in their respective bikes get your diaphram's spring checked, it might be the culprit.

                      Also get the diaphram checked for currect fitment, around the circumfrence.
                      Plus the placement of the pin.
                      The Magician"

                      Comment

                      • #3491
                        Originally posted by rennycornelius View Post
                        Plus the placement of the pin.
                        If the main jet holder is not tightened well, then also it will give hiccups.
                        There's lot to it other than saddle....


                        sigpic

                        Comment

                        • #3492
                          Originally posted by nox2505 View Post
                          If the main jet holder is not tightened well, then also it will give hiccups.
                          What about the diaphram buddy??
                          i think the main diaphram supplied might be hard or getting crickled over the period of time from the cuircumfrence and might be arising this issue.
                          The Magician"

                          Comment

                          • #3493
                            Originally posted by rennycornelius View Post
                            What about the diaphram buddy??
                            i think the main diaphram supplied might be hard or getting crickled over the period of time from the cuircumfrence and might be arising this issue.

                            Diaphram will not give issue till it is teared. Minute leakage from perifery will affect progressive throttle opening (practically very dificult to feel) and not quick throttle opening.
                            There's lot to it other than saddle....


                            sigpic

                            Comment

                            • #3494
                              I think some kind of vaccum is created inside the carb which results in hiccups.

                              Just a wild guess!!

                              sigpic

                              Comment

                              • #3495
                                Originally posted by rennycornelius View Post
                                All the owners who are facing the hiccups problem plz report here with date of purchase and kms logged.
                                16th April 2010, 1500 kms done!

                                Comment

                                Previous 1 133 183 223 228 229 230 231 232 233 234 235 236 237 238 243 283 333 733 1233 1275 template Next
                                Working...
                                X
                                © xBhp.com 2026. All rights reserved.
                                Designed by xBhp