Ok guys, as promised; here are the steps to fixing the angel eye/corona rings/DRLs to the bike.
1. Open the visor (6 screws), remove the RVMs (4 screws), open the black cladding around the console (6 screws), open the upper fairing from both sides (14 screws).
2. Now, remove 4 screws to unmount the headlamp assy (accessibility is tricky, but can be done from the handlebars side - above the dual horns)
3. Remove the number plate holder (2 screws)
4. Remove the reflector from the glass shield (requires a screw driver) by pulling it apart carefully - this takes more time compared to opening and fitting back the whole setup!
5. After the reflector is separated, ensure that the gum/sealant used by OE is removed properly.
6. Remove the bulb and keep it safe.
7. Fix the ring with a double sided tape (backfired a bit in my case though) to maintain a stable position and apply gum/sealant/fevibond to secure the ring in place.
8. Leave aside for 20 min.
9. Reseal the headlight assy (reflector + glass) with rubber based sealant (don't use fevibond/fevicol etc here)
10. Connect the rings to pilot lamps socket and tape it well.
11. Fix back all screws!

Only pilot lamps working.
With the headlamp switched on (low beam).



go to task killer and kill it.. every time you get a notification from the forum.. open it thru forum.. then it directs you to the threads 


Comment