thank you all guys... your inputs were really helpful... will test again with the same pillion and report the new top speed...

@ pruthviqa
I used to get 35 kmpl before first service now its increased to 40-45 depending on heavy traffic or light traffic..

Can anybody take the pain of measuring the length of rear shocks of ZMR for me? I would highly appreciate that.

i will give you by today night
right now i am in pune
missing zmr badly

and u didnt take the bike ?

Measure from where to where?? Gimme some details about how to measure, as the shocks are going inside the rear panels and cannot be measured directly.

Nope
without ZMR

some problem with bangalore RTO ,registeration is not happening.any of u guys facing this issue?(from last week).

Fisrt service done & some photos

I know its very late to post photos...........

I have done my 1st service on the 5th day of the delivery............on saturday at 700 kms...............i found out some problems with SVC.............they are not caring the job sheet they have taken............One screw of my wisor was missing along with one bol of the silencer pad...........i told them in the morning...........In evening I have noticed that they have done nothing to both the matter.........Then they fixed the wisor probs......but they told me that the silencer pad bolt is broken and ll take time to replace...............after a lot of struggle they agreed that it may be an unloading problem......( I could nt do a thorough check up as it was at 6pm I got the bike) What to do now?


After that on sunday went a trial run to thrissur (a 180 km oneside) for the tri state G2G..........but it resulted in another roadtrip to Nelliampathy........(Hope my fellow Cochin BHPians will write about it). I started in the early morning of 4 am................atlast my zmr is now clocking 1300 kms on the 2nd day after the 1st service..............


May I rev it to give the higher speeds?

yes for sure now you can ride in the way you want.

Hurrrrrrrrrrei.............
Thanks buddy

by when we can take ZMR to high speed..after 2nd servicing or after 1k km or any other?

anyone can answer me plz

friends by installing k&n can we increase bhp of our bike...???

I think yes... more air is drawn hence more fuel(the ecu maintains a constant AF ratio) this directly translates to more power and hence higher bhp

but i was thinking of the damage to the engine if any??

I think it is better to search for ECU reprogramming options.... We can boost up the power just by doing that

and in my opninon no one will start messing with their machines so early, we have to wait atleast for a year before we go for mods...