Thanks for the quick reply everyone! My bike has done ~1800Km bought on 7 June and runs in chandigarh and solan, Himachal.
I lube it with Total car gear oil 80W90 after every 400Km or so which takes maybe 10 days. SO was not expecting this. However this was in the morning when it had rained quite a bit in the night.


I do lube with 80W90 gear oil ~ 400kms. Is that not good enough?


Problem is i have zero trust on the dealer. For the sound, vibration issues they just say its normal without even looking at the bike!! they gave me a fake centre stand with no MRP or hologram on the pack and simply dont believe in giving bills. And being a small city the mechanics are really clueless about the bike and their service standards are bad even by the pathetic bajaj standards. Can i go to a different dealer in chd for this? BTW bike is ~ 1800KM.


Thanks for the reply krishna. No its not coastal, infact im atleast a 1000km from the nearest coast. Im in chandigarh and himachal pradesh. So no coastal mud, its himalyan mud! Does this make a difference? Is this a serious issue if not coastal area?




Thanks. Will clean the chain. SO this kind of rust is normal ??

Maybe some more pics from the same day would help:

[ATTACH]189641[/ATTACH]

[ATTACH]189640[/ATTACH]

Here few more pics.



Sent from my HTC One M9PLUS using xBhp Connect mobile app

hi,

this is normal in rainy days.. to avoid try to use chain clean and lube.. keep ur chain lubricated..

you can use the brush to clean it properly..

i use this to keep my chain clean n clear..

That's nice, thanks for sharing. By the way, did you try recording videos?, i mean dashcam video while riding?, is it very shaky?.

The video will not be very shaky if What device u using to record has OIS.(optical image stabilization)
Else it will be quite shaky.

Sent from my HTC One M9PLUS using xBhp Connect mobile app

oh, I dont have one and the gopro cameras are a bit costlier. Thanks anyway

Hi i am done with the run in period almost i had covered 2800 kms on ns. what gearing ratio should be ideal now or till the time you feel smooth in one gear. Asking this because want to know till what limit i should take any gear on with the speed

Sent from my Xperia SP using Tapatalk

Now u can ride hard buddy [emoji12] [emoji12] but ride safe [emoji5]

Sent from my MI 4W using Tapatalk

Yup doing that, in a bile ride just touched 122km/hr[emoji4]

Sent from my Xperia SP using Tapatalk

I touched 132 once and that was horrible ns is not at all stable at higher speed [emoji25]

Sent from my MI 4W using Tapatalk

I touched 132 once and that was horrible ns is not at all stable at higher speed [emoji25]

Sent from my MI 4W using Tapatalk

have anyone felt the nuts getting too loose on the bike? the big nut below the handlebar was loose , had to got it tightened up ( i knew it was loose,as Bike used to produce loud noise when going in pothole). Recently i went for a 400 km ride and midway into the ride noticed the Gear shifter allen bolt was about to drop off, i had to tighten it with my hand. also i have lost one bolt from front and rear number plate over last 5.7k km,they simply fell off.

is this happening due to excessive vibrations? my bike has increased vibrations over time (completed 5.7k kms), i suspect mounting bolts might be loose too as some posts online suggest. Engine oil is motul 5100/Air filter was cleaned yesterday.also, Vibrations go away if i press the clutch.

what kind/comapny of allen key tookit you use? i bought one from market and it slips while tightening bolts, need to get a better quality one.

Or maybe you are overtighting bolts which is causing the loose of bolts bracket?

Sent from my SM-G7102 using Tapatalk

loosing of bolt brackets? i understand what you mean but i dont think bolt bracket can crack. will recheck .