Tweet
Originally posted by rennycornelius
View Post
-
not after 8K rpm, but after 6K to 8K it vibrates a lot -
Wait for few days and keep ur eyes open here, Soon I am going to mod my airfilter with a paper one. No its not a KN but it will give better performence then KN, without much herm to ur bike and cost wise it will be way cheaper then the KN.Originally posted by arunprasath View Post
KN RC 1060 cost almost Rs.1600
My new paper Airfilter cost only Rs.200.
Just need a good 2-3 hour to done that, but office
BTW my idea was already supported by TVS service engineer.sigpicComment
-
can someone confirm ? may be joel....Originally posted by rider_rock View Post
these days my geo cruiser is skidding a lot, dunno why, so thinking of going for r15's rear tyre, but its of 17'', and ours is 18'', so any suggestion guys ??
thinking of zapper q, but dunno will i find it here in kolkata...Last edited by psycho28; 03-03-2009, 12:05 PM.Comment
-
are you from kolkata ?? which sc do you go ?? i dont find a good sc guys here in west bengalOriginally posted by kauria View PostWait for few days and keep ur eyes open here, Soon I am going to mod my airfilter with a paper one. No its not a KN but it will give better performence then KN, without much herm to ur bike and cost wise it will be way cheaper then the KN.
KN RC 1060 cost almost Rs.1600
My new paper Airfilter cost only Rs.200.
Just need a good 2-3 hour to done that, but office
BTW my idea was already supported by TVS service engineer.Comment
-
The tacho vibes is the same on my bike too. Guess its a common issue with the RTR's....Democracy is when 2 wolves and a sheep meet to decide who is for dinner. Liberty is when the sheep has a gun.Comment
-
The vibration is so high that i can see the needle vibrating ranging 1k rpm.. the needle will be present at 9k rpm and 10k rpm at an instant ... its faster than light :POriginally posted by Aparajith View PostLets put a smile on your faceComment
-
i have been noticing some abnormal behavior with the tacho needle for last couple of days.
yesterday, after a 15km drive in city, the needle showed 800rpm in neutral..but going by the sound, it was maybe at 1400 rpm
today, after again after a 15kms drive home -> office - tacho shows 200rpm in neutralComment
-
Gud I wanted to know about the tubeless tyres...Originally posted by jasmeetsinghchawla View Post
For all you Hip Hop Fans out there, check out our tracks at
Comment
-
it started doin this 5 days back.......Originally posted by psycho28 View Post
but man the needle vibrates like nythin.....The Magician"
Comment
-
-
Originally posted by kauria View Post
i tried it in brand new fi too.....
but it was not getting violent as it is in my bike.....
is it due to engine vibrations travellin to it or is it a diff issue?????The Magician"
Comment
-
for all those who have rpm needle vibe problem
Pls check if ur needle shoots up smoothly.
Start ur bike and warm it up let it settle in idle rpm and then at an instant rev it as it has to hit 11k rpm. see if the needle hit the 10k or 11k mark easily. if the needle get stuck at 6k rpm and falls back to zero. get ur speedo replaced under warrenty
try this for quiet sometime. this is exactly why my speedo was replaced twice!07 HH Zma
11 Honda Aviator DLX
14 Ford Figo 1.4 TDCI (Now Caged:( )
16 Scooty Zest
11 CBR 250RComment
-
will be doin it ASAP........Originally posted by onlinesatish View Postfor all those who have rpm needle vibe problem
Pls check if ur needle shoots up smoothly.
Start ur bike and warm it up let it settle in idle rpm and then at an instant rev it as it has to hit 11k rpm. see if the needle hit the 10k or 11k mark easily. if the needle get stuck at 6k rpm and falls back to zero. get ur speedo replaced under warrenty
try this for quiet sometime. this is exactly why my speedo was replaced twice!
thanks mate.....The Magician"
Comment
-
do the alloys support tubeless tyresQuote:
Originally Posted by jasmeetsinghchawla
Tubeless tyres can be put without any mods given the size, but for the tank scoops new tank has to be installed.
Gud I wanted to know about the tubeless tyres...
sigpic
When a man has pity on all living creatures then only is he noble. ~Buddha~noble.org.inComment
-
Why not. All alloy wheels do.Originally posted by rider_rock View Postdo the alloys support tubeless tyressigpic
[email protected]Comment
Comment