Hi guys.
Few weeks ago I changed bike's plug cap with Hero OE. But again it got corroded(greenish coating on inside screw). So I decided to get a better plug cap. As I had already read in this thread that Hero's plug cap has 5k ohm resistor in it whereas Pulsar's plug cap has 1k ohm and members are using pulsar plug cap without any problems. So I changed plug cap to pulsar's and used rubber sealing boots from an aftermarket plug cap. Throttle response got a bit better. Covered 500kms with this setup(Pulsar plug cap+NGK CR6HSA) and no problems at all.
Also today after clocking 2000+ kms on Hero oil replaced it with Veedol Takeoff 4t Premium 10w30 (Cost Rs.240/- for 900ml can). First time using any other oil than stock. Gearshifts are buttery smooth now. Way better than before. As it was my first DIY oil change, I took extra care of tightening the drain bolt. First fully tightened with fingers then using ring spanner, gave it a slight jerk by holding the spanner with thumb and index finger. No oil leaks till now. Just covered 10kms post oil change. Will update its condition after 1-1.5k kms.



Comment