Nope. No such problem with my bike.

Then its tuning problem even my dtsi has the same problem irregular throttle response between 1-2k rpms in 1st 2 gears after that every thing will be fine the pbk mech drained the carb and tuned now the problem is gone since urs is FI only tuning might be the issue cleaning the tank might also help occurs mostly beacause of bad petrol.

OK.. i ll check it again the co setting they might be reduced co %.

Also clean the fuel tank impure matter and water may accumulate in it these things can reduce jerks and missing prbs at lower rpms.

Fuel tank is already cleaned for impure matter and water. now waiting for Appointment at PBK.

bought new pulsar 220s give me the tips how to maintain

Dear Sanjay

Kindly use this link to post your query in the P220 DTSI thread this is for P220 FI
Link http://www.xbhp.com/talkies/motorcyc...-220-dtsi.html

chain cleaning to be done at how many kms?

Pulsar 220 DTS-FI Engine stalling

Hi

I own Bajaj Pulsar 220 DTS-FI from Oct.2007.

Clocked only 3900 KM.
Because of my transfer to differant district could not used bike for 1.5 year.

Recently I was facing so many problems with my bike.

1) Engine Stalling
2) Rough Acceleration
3) Gear shifting hard
4) faulty Rear Brake Caliper
5) Rusted Fuel Tank & fuel pump.
6) Weak Front Sturts
7) Hard Rear Sturts

So I had to bear heavy repair bill of Rs.15000/-

Changed Fuel Tank & Fuel Pump
Changed Rear Brake Caliper
Changed Throttle Body
Changed Front Sturt Springs & Rear Sturts
Changed Clutch Plates & Balalncer
Changed Stator Plate due to error of Crank Angle Sensor.

Other problems solved . But still my bike stalls.
Especially at cold start,if I put headlamp ON , Humming noise of Fuel pump becomes dull & after 10 Sec.fuel pump humming noise becomes just like it is running on Magneto Current only.

I know that on headlamp ON position humming noise of Fuel Pump can be changed.
But humming should be constatnt even on headlamp position ON . It should not vary. Am I Right ?

I mean at cold start if I put lamp ON,it feels that bike has no DC battery.& fuel pump is running on Magneto Current only.
Humming of fuel pump should be constant. But in my case fuel pump humming noise varies as per strokes of bike. & after 10 Sec.engine goes OFF.

I checked by replacing Battery & Capacitor also. But could not success.

As per PBK guys,Fuel pump of FI Pulsar can't run on Magneto. Battery should be powerfull.

So I measured Battery charging voltage. As per Training Notes of Pulsar
@4000 RPM Multi-Meter should indicate 14 Volt on Headlamp ON & OFF position.

In my bike
At Headlamp OFF position,charging voltege is below 14 V
At Headlamp ON position,charging voltege is 14 V.

As per Spare Part Catalogue of Pulsar 220 FI has 2 Regulators.

1) AC/DC Regulator - Part No. DJ201102
2) Voltege Regulator - Part No.DK201001

I found Voltege Regulator DK201001 below the seat which have Alluminium body.
But could not find DJ201102 AC/DC Regulator.

I have Spare Part Catalogue. In Catalogue Bajaj has displayed both Regulators.

But as per my info,Pulsar 220 FI has DC Ignition.
I think for 220 FI, Bajaj has shown AC/DC Regulator - Part No. DJ201102 by mistake.

I think problem is due to improper battery charging.

So DTS-FI may not have AC/DC Regulator.

Please help.

Depends on your usage normally i clean the chain at 1000-1500 kms

Finding little tough to reach out Motul 300v.. got used to it for past 35k.. need suggestions on next best Engine oil for p220.. about 60% of my ride is at highways at higher RPMs (6k-8k)

my 220 completed 4 yrs on saturday at 5 pm

Usage dependent. Cleaning+Lubing should be done every 500Kms, and correcting the slack should be done every 1000 Kms.

The 220Fi has only 'DK' part number as far as I know. The RR unit under the seat is related to battery charging. Which month/year is your bike from?

The RR unit and a couple of other things were upgraded for the most of under warranty a couple of years back when the bike was new.

Don't go too much with the sound of the pump, after priming is the bike running fine or is it still jerking?

Motul 5100T then, or you are not able to source Motul at all? Spoke to Apar? He must know some places for 300V.

Else the fully synth oil from Castol is also good from what people say, I somehow can't trust castrol. There's even the Valvoline Premium 4T, but that will last only 2.5K as its a Semi-synth!

Congrats dude

Praful, did you change the rear disc caliper to the new Bybre one...?? I have a doubt to clarify with an experienced person...

Nope, not yet change. Still thinking about it. 90% will not go for it! Why?