Tweet
Experts... please have a look at my spark plug...
Attached Files
-
-
What kind of information?Originally posted by Aneesh@4GHz View PostGreat.Can you provide more information on this?
okay look at its size
The other three pins here are work as input output either way. Other two are for Inner Magnet Coil Input.
Dimensions measured with a Micro Millimeter.
The one i've created and using in my bike. I made a plate to cover for fixing it with a bolt.
The wires are well soldered and covered with a sleeves, so they are not going to break in its lifetime.
here blue & black are the input to magnet coil from stock horn wires. Whereas, other are for input (from battery) & output (to the horn). Therefore, they are thicker wires.
Your AFR tuning is perfect.Originally posted by aarunn View PostLast edited by paul.1911; 10-23-2012, 06:28 PM.| SOL 68s | Rynox Tornado Pro | Rynox Advento | Cramster TRG2 | Scoyco MC20 | Hero 5 and SJ6 |
Adjusting Tappets FZ25 www.youtube.com/watch?v=VhiJGtd_Xigl
Engine Oil & Oil Filter Change www.youtube.com/watch?v=9AZ5MlXF7dc
Visit here for more DIY www.youtube.com/c/LifeofPal
DIY - Foam Air filter Cleaning & Oiling / Horn Repair Guide / Replacing Motorcycle Fork Oil
Read This Before You Buy Any Halogen Bulb
Engine OverhaulComment
-
@Arunn- From the picture above, I tend to think you are running lean. Are you running on 3.5 turns?RX100 1996 | Karizma 2004 | Karizma-R 2011 | RXZ 1999 | RX 135 1998 | RX 100 1993 | CBF150 2005 - 2011
2012 - Meghamalai | Kuttralam | 2011 Ooty | Munnar | 2010 Point Calimere | Horsley Hills | YercaudComment
-
Your G power plug shows lean running...here is picture which will help you to read the plug....Originally posted by aarunn View Post
When Was The Last Time,You Did Something For The First Time.Comment
-
Psr sir,excellent infoComment
-
[QUOTE=psr;885553]Your G power plug shows lean running...Originally posted by SriramEfunds View Post
My AFR screw is stuck
Tried wd 40 which dint work... can u guys suggest any other methods?
Comment
-
[QUOTE=aarunn;885743]Try cyclo carb cleaner or take a small piece of cotton wet with kersone and leave it overnight., if still doesnt work. Take out the carb, take a wooden piece, keep it on the top of AFR screw and hit it very slightly with a smaller size hammer. Repeat this two three times and try.Originally posted by psr View PostMy AFR screw is stuck Tried wd 40 which dint work... can u guys suggest any other methods?
Put the cotton in the end of screw driver, wont damage the screw top, also hold the cotton on your hand with screw driver, if u feel u r putting more torque.| SOL 68s | Rynox Tornado Pro | Rynox Advento | Cramster TRG2 | Scoyco MC20 | Hero 5 and SJ6 |
Adjusting Tappets FZ25 www.youtube.com/watch?v=VhiJGtd_Xigl
Engine Oil & Oil Filter Change www.youtube.com/watch?v=9AZ5MlXF7dc
Visit here for more DIY www.youtube.com/c/LifeofPal
DIY - Foam Air filter Cleaning & Oiling / Horn Repair Guide / Replacing Motorcycle Fork Oil
Read This Before You Buy Any Halogen Bulb
Engine OverhaulComment
-
[QUOTE=aarunn;885743]apply brake oil and wait for 15~20 minutes. If the screw still doesn't move, then take a TESTER screw driver,place it on the AFR screw,and gently tap the screw driver with a size10 or 12 spanner. Be gentle with tapping because if you use excess force it will destroy the carburetor permanently..try rotating the screw CLOCKWISE...if still stuck apply brake oil/WD40/Zorrick and again repeat the sameOriginally posted by psr View PostYour G power plug shows lean running...
My AFR screw is stuck Tried wd 40 which dint work... can u guys suggest any other methods?
Again do not tap with high force as it will ruin the carburetor.When Was The Last Time,You Did Something For The First Time.Comment
-
Friends, is this logo looks good instead of 'Hero' ?
I really can't define myself without my bikeComment
-
-
Is this HIDOriginally posted by jpZMA View Post
I need some advised. I have old karizma just before R model.
1- Is this Kit easily install in my Karizma. MOTORCYCLE/BIKE HID XENON HIGH/LOW BEAM H4 6000 K LIGHT WITH FULL WIRING KIT | eBay
2- Want change my stock filter the the yellow one inside seat with something which you guys suggest if it's good only then. And what other part can replace.
3- Near fuel tank the paint get off was thinking to paint whole tank but the problem is to find golden Karizma sticker or I have go Karizma R sticker then also need to change the whole body sticker. Don't know how much it will cost me.
Will be back with more query.Last edited by NIGHTMARE; 10-25-2012, 04:31 PM.Comment
-
Welcome to xbhp, friend.Originally posted by NIGHTMARE View Post
No dear, its not HID, its the bright white LED pilot lamps.
1. Yes you can install the above HID in your ZMA, but it is not recommended due to safety reasons on the incoming vehicles.
2. Are you asking about the air filter?
3. How bad is that? can you post some images so that experts can suggest.
anyway original body stickers are not easily available, the replicas (OEM quality) costs around 500-600 rs for total body.I really can't define myself without my bikeComment
-
Guys , i am confused between which grade engine oil is better for zma ?
10w30 or 15w50 ?
one off my friend say that 10w30 too thin oil and engine will get very heat up while using it .Angel in CITY , DEMON on HIGHWAY .
Comment
-
Thank you very much for warm welcome.Originally posted by jpZMA View Post
Can show me the close picture or refer link.
1- Sorry mine is not ZMA the old one, older model than Karizma R. So which bulb you will recommend or any expert advise is most welcome.
2- Yes air filter.
3- Some moron painter clean the portion by using thinner.
Sure will post the picture tomorrow for both filter and fuel tank.Comment
-
link LED pilot lampsOriginally posted by NIGHTMARE View PostThank you very much for warm welcome.
Can show me the close picture or refer link.
1- Sorry mine is not ZMA the old one, older model than Karizma R. So which bulb you will recommend or any expert advise is most welcome.
2- Yes air filter.
3- Some moron painter clean the portion by using thinner.
Sure will post the picture tomorrow for both filter and fuel tank.
1. I think osrm night breaker/philips xtreme vision 55/60w with a relay should be good for your common needs. I am not sure about your battery power whether it is 9Ah or not. Aneesh bro can explain better as he owns the same model you own
2. you should change your Air filter in every 10k according to your road conditions. It is a straight fit & costs arround 200rs, if you want to change your stock filter then you have to make some modifications to your carburator.
3. Waiting for your uploads
Friend, I think motul 20w40 mineral is best for ZMA and lasts upto 2000-2200 kms just for only 230 bucksOriginally posted by rajdiceman View PostLast edited by jpZMA; 10-26-2012, 12:34 PM.I really can't define myself without my bikeComment
Comment