Tweet
Originally posted by nand15
View Post
-
there was about 2 litres of petrol in it.. -
Ride in for sometime and it will reset correctly. It's a common problem with R15 v2.0. After it get's into reserve, the reserve indicator does not stop even after a tank up till you ride for sometime.Originally posted by appusvivek View Posti have an r15 2.0 , its been 2 months since i have bought it. everything was ok since last week the fuel gauge started blinking i thought it was because my bike was in reserve but even after i refueled the fuel gauge indicator is still blinking. what should i do? im so tensed
please reply.Comment
-
sir but its been a long time..i have ride it after refueling , daily but still its blinkingOriginally posted by abhisheksircar View Post
Comment
-
Bro, stop worrying too much. Its such a minor issue(if it is an issue at all), digital fuel guages are very unreliable, irrespective of make of the bike, if you notice, the gauge shows different reading when the bike is going uphill and downhill, the ball senson inside the tank keeps shifting position, nothing else, in your case , worst case scenario the fuel sensor might be having some damage, get it replaced under warranty, problem solved.Originally posted by appusvivek View Postsir but its been a long time..i have ride it after refueling , daily but still its blinking
Cheers
Ride Safe
krishna--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Run-in Procedure | Power Loss Solutions | Riding Gears 101 | Biking Brotherhood
Pulsar 220F|2013 Honda CBR250R|KTM Duke390|Yamaha R3|Yamaha R1|Triumph Tiger XRXComment
-
Originally posted by appusvivek View Postsir but its been a long time..i have ride it after refueling , daily but still its blinking
Find the below pic taken while doing a fuel pump clean (20P) for one of our customers.
The black fiber piece will float up and down on the fuel level, hence the corresponding reading will be displayed on the meter. May be this component is malfunctioning in the fuel pump, better take to a nearby service to check the fuel pump and if found faulty the entire fuel pump will be replaced.
What do you mean Fuel Sensor?Originally posted by krish2778 View Post
There is no rule that a digital speedo is inaccurate or less efficient than analog ones.Comment
-
Dont panic man. Juz dont panic.Originally posted by appusvivek View Postsir but its been a long time..i have ride it after refueling , daily but still its blinking
The black fibre ball is probably bursted or broken. Get it replaced. Big deal. Shit happens. And this isnt even shit. There are worse cases on this very thread.__________________________________________________ __________________________________________________ _______
Viaterra Rapide - A Comprehensive Product Overview
The Art Of Cornering - lots and lots of knee down pics
Originally posted by Prakash Solanki
FacebookComment
-
i think so may be the damage is with fuel sensor right? ok thanks for the tip.Originally posted by krish2778 View Post
thanks bro i will take my bike to service and find out why this happenedOriginally posted by HarishK View PostFind the below pic taken while doing a fuel pump clean (20P) for one of our customers.
The black fiber piece will float up and down on the fuel level, hence the corresponding reading will be displayed on the meter. May be this component is malfunctioning in the fuel pump, better take to a nearby service to check the fuel pump and if found faulty the entire fuel pump will be replaced.
What do you mean Fuel Sensor?
There is no rule that a digital speedo is inaccurate or less efficient than analog ones.
Originally posted by ABikerAtHeart View PostComment
-
i have a doubt guys if my digital meter is damaged ,if i should get it replaced how much would it cost me?
Comment
-
Originally posted by appusvivek View Postsir but its been a long time..i have ride it after refueling , daily but still its blinkingThanks for sharing the pic manOriginally posted by HarishK View PostFind the below pic taken while doing a fuel pump clean (20P) for one of our customers.
The black fiber piece will float up and down on the fuel level, hence the corresponding reading will be displayed on the meter. May be this component is malfunctioning in the fuel pump, better take to a nearby service to check the fuel pump and if found faulty the entire fuel pump will be replaced.
What do you mean Fuel Sensor?
There is no rule that a digital speedo is inaccurate or less efficient than analog ones., its really good to know.
I doubt it would happen in 2 months time unless you are riding bike constantly close to reserve as the thumb rule says your fuel meter if it stays to one bar better to go and refuel till full tank as that keps the fuel pump in best health.Originally posted by ABikerAtHeart View Post
You do a full tank and ride for 30 kms and see if the reserve blink stops. How you know its damaged? What are the symptoms ?Originally posted by appusvivek View Posti have a doubt guys if my digital meter is damaged ,if i should get it replaced how much would it cost me?Comment
-
Hi
Yeah even i have noticed some amount of rust in the same place. The service guys say that ain't a problem. But I am worried... any suggestion to overcome it???With Gears,
Sabiking
"Breathe Bike"Comment
-
By fuel sensor i meant that the corresponding level of the ball must translate into different bars on the digiatal speedo, which requires some kinda sensor.Originally posted by HarishK View Post
And i never mentioned it being more inaccurate than an analog meter or any rules of any kind, all i mentioned was the digital meter shows various readings in an uphill and downhill condition, which is evident.
Cheers
Ride Safe
Krishna--------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Run-in Procedure | Power Loss Solutions | Riding Gears 101 | Biking Brotherhood
Pulsar 220F|2013 Honda CBR250R|KTM Duke390|Yamaha R3|Yamaha R1|Triumph Tiger XRXComment
-
need suggestion
installing only daytona exhaust will cause any problem i mean valve leakage as it is a ffe and thus cause excessive pressure on the exhaust valve ??? all please correct me if i am wrong pl educate me
Comment
-
My bike's head-cylinder gasket is defective and so the oil+ coolant is leaking. The cylinder would be opened to check whether there is leak internally also. Can someone post a pic depicting a properly run cylinder or a pic of a cylinder with leak ?it would be of great help to identify the problem! Thanks in advance.Rx is a Phoenix!!! It always rise from ashes!!Comment
-
kit
no it wont cause any problem i have whole kit no issuesOriginally posted by sunny9830687955 View Postinstalling only daytona exhaust will cause any problem i mean valve leakage as it is a ffe and thus cause excessive pressure on the exhaust valve ??? all please correct me if i am wrong pl educate meComment
-
I feel that my bike has some alignment issue...have to go to SVC again...might be a coneset issue, but need to check it!!Comment
Comment